Intel FPC 5084, N270 user manual Mountings Panel/Wall/Desktop/VESA, Panel Mounting

Page 22

FPC 5084

2.4Mountings – Panel/Wall/Desktop/VESA

There are several mounting ways for the FPC 5084, Panel, Wall, Desktop and VESA mountings.

2.4.1 Panel Mounting

The FPC 5084 is designed for panel mount application. A set of standard mounting kit are bundled with the system package that you can use it to mount the FPC 5084.

14	Hardware Installation

Image 22

Contents FPC Disclaimers Safety Approvals FCC ComplianceSafety Precautions Trademarks Acknowledgments Table of Contents Drivers Installation Memo General Description Reliable and Stable DesignSpecifications Main CPU BoardSystem Specification 2 I/O SystemFPC Dimensions FPC I/O Outlets Packing List Chapter Hardware Installation CF card InstallationHardware Installation Serial Ports Interface Signal Name Pin Signal EthernetMountings Panel/Wall/Desktop/VESA Panel MountingWall-Mounting Desktop-Mounting Hardware Installation VESA-ARM Mounting Vesa mounting Installation completed FPC Dram Installation FPC Wireless LAN Card Installation FPC Memo Page Starting Navigation KeysMain Menu System Time/DateAdvanced Menu Max Cpuid Value Limit Configure advanced CPU settingsExecute-Disable Bit Capability Hyper Threading TechnologyIDE Configuration Enhanced C-StatesSerial Port2 Address Serial Port1 AddressSerial Port1 IRQ Serial Port2 IRQSerial Port4 Address Serial Port4 IRQHardware Health Configuration System Temperature/CPU TemperatureAcpi Settings Power Management/APM APM ConfigurationVideo Power Down Mode Suspend Time Out Minute Hard Disk Drive Power Down ModePower Button Mode Throttle Slow Clock RatioResume On RTC Alarm Advanced Resume Event Controls Resume On RingMPS Configuration MPS RevisionPCI Express Configuration Active State Power-ManagementSB Pcie Ports Configuration Bios Ehci Hand-Off USB ConfigurationUSB 2.0 Controller Mode Legacy USB SupportPCI PnP Menu Plug & Play O/S PCI Latency TimerClear Nvram Allocate IRQ to PCI VGAOffBoard PCI/ISA IDE Card Palette SnoopingPCI IDE BusMaster IRQ3/4/5/7/9/10/11/14/15Boot Menu AddOn ROM Display Mode Boot Settings Configuration Quick BootQuiet Boot Boot Num-LockBoot Device Priority Wait For ‘F1’ If ErrorHit ‘DEL’ Message Display Removable Drives Lan Boot Settings Configuration Change Supervisor Password Supervisor PasswordUser Password Change User PasswordBoot Sector Virus Protection Chipset Menu Boot Graphic Adapter Priority North Bridge Configuration Dram FrequencyConfigure Dram Timing by SPD Internal Graphics Mode SelectAMI Bios Setup Utility South Bridge Configuration USB Function Restore on AC Power LossPcie Port Configuration USB 2.0 ControllerDiscard Changes and Exit Exit MenuSave Changes and Exit Discard ChangesLoad Optimal Defaults Load Fail-Safe DefaultsChapter Drivers Installation SystemDriver Installation- Windows XP SpecificationTouch Screen FPC Installation of Drivers Windows XP Embedded Embedded O.SPenMount Touch screen Windows CE.NET Calibration Touch screen