Intel N270, FPC 5084 user manual Advanced Menu

Page 37

FPC 5084 User Manual

System Time or System Date using the <Arrow> keys. Enter new values through the keyboard. Press the <Tab> key or the <Arrow> keys to move between fields. The date must be entered in MM/DD/YY format. The time is entered in HH:MM:SS format.

3.4Advanced Menu

The Advanced menu allows users to set configuration of the CPU and other system devices. You can select any of the items in the left frame of the screen to go to the sub menus:

￿CPU Configuration

￿IDE Configuration

￿SuperIO Configuration

￿Hardware Health Configuration

￿ACPI Configuration

￿APM Configuration

￿MPS Configuration

￿PCI Express Configuration

￿USB Configuration

For items marked with “f”, please press <Enter> for more options.

AMI BIOS Setup Utility

27

Image 37
Contents FPC Disclaimers FCC Compliance Safety ApprovalsSafety Precautions Trademarks Acknowledgments Table of Contents Drivers Installation Memo Reliable and Stable Design General DescriptionMain CPU Board Specifications2 I/O System System SpecificationFPC Dimensions FPC I/O Outlets Packing List CF card Installation Chapter Hardware InstallationHardware Installation Serial Ports Interface Signal Name Ethernet Pin SignalPanel Mounting Mountings Panel/Wall/Desktop/VESAWall-Mounting Desktop-Mounting Hardware Installation VESA-ARM Mounting Vesa mounting Installation completed FPC Dram Installation FPC Wireless LAN Card Installation FPC Memo Page Navigation Keys StartingSystem Time/Date Main MenuAdvanced Menu Execute-Disable Bit Capability Configure advanced CPU settingsMax Cpuid Value Limit Hyper Threading TechnologyEnhanced C-States IDE ConfigurationSerial Port1 IRQ Serial Port1 AddressSerial Port2 Address Serial Port2 IRQSerial Port4 IRQ Serial Port4 AddressSystem Temperature/CPU Temperature Hardware Health ConfigurationAcpi Settings Power Management/APM APM ConfigurationVideo Power Down Mode Power Button Mode Hard Disk Drive Power Down ModeSuspend Time Out Minute Throttle Slow Clock RatioAdvanced Resume Event Controls Resume On Ring Resume On RTC AlarmMPS Revision MPS ConfigurationActive State Power-Management PCI Express ConfigurationSB Pcie Ports Configuration USB 2.0 Controller Mode USB ConfigurationBios Ehci Hand-Off Legacy USB SupportPCI PnP Menu Clear Nvram PCI Latency TimerPlug & Play O/S Allocate IRQ to PCI VGAPCI IDE BusMaster Palette SnoopingOffBoard PCI/ISA IDE Card IRQ3/4/5/7/9/10/11/14/15Boot Menu Quiet Boot Boot Settings Configuration Quick BootAddOn ROM Display Mode Boot Num-LockBoot Device Priority Wait For ‘F1’ If ErrorHit ‘DEL’ Message Display Removable Drives Lan Boot Settings Configuration User Password Supervisor PasswordChange Supervisor Password Change User PasswordBoot Sector Virus Protection Chipset Menu Configure Dram Timing by SPD North Bridge Configuration Dram FrequencyBoot Graphic Adapter Priority Internal Graphics Mode SelectAMI Bios Setup Utility South Bridge Configuration Pcie Port Configuration Restore on AC Power LossUSB Function USB 2.0 ControllerSave Changes and Exit Exit MenuDiscard Changes and Exit Discard ChangesLoad Fail-Safe Defaults Load Optimal DefaultsSystem Chapter Drivers InstallationDriver Installation- Windows XP SpecificationTouch Screen FPC Installation of Drivers Windows XP Embedded Embedded O.SPenMount Touch screen Calibration Touch screen Windows CE.NET