Intel FPC 5084, N270 user manual APM Configuration, Power Management/APM, Video Power Down Mode

Page 44

FPC 5084

￿APM Configuration

You can use this screen to select options for the APM Configuration, and change the value of the selected option. A description of the selected item appears on the right side of the screen.

￿Power Management/APM

Set this item to allow Power Management/APM support. The default setting is Enabled.

Set this item to prevent the chipset power

Disabled management and APM (Advanced Power

Management) features.

Enabled

Set this item to allow the chipset power management and APM (Advanced Power Management) features. This is the default setting.

￿Video Power Down Mode

This option specifies the Power State that the video subsystem enters when the BIOS places it in a power saving state after the specified period of display inactivity has

34

AMI BIOS Setup Utility

Image 44
Contents FPC Disclaimers Safety Approvals FCC ComplianceSafety Precautions Trademarks Acknowledgments Table of Contents Drivers Installation Memo General Description Reliable and Stable DesignSpecifications Main CPU BoardSystem Specification 2 I/O SystemFPC Dimensions FPC I/O Outlets Packing List Chapter Hardware Installation CF card InstallationHardware Installation Serial Ports Interface Signal Name Pin Signal EthernetMountings Panel/Wall/Desktop/VESA Panel MountingWall-Mounting Desktop-Mounting Hardware Installation VESA-ARM Mounting Vesa mounting Installation completed FPC Dram Installation FPC Wireless LAN Card Installation FPC Memo Page Starting Navigation KeysMain Menu System Time/DateAdvanced Menu Configure advanced CPU settings Execute-Disable Bit CapabilityMax Cpuid Value Limit Hyper Threading TechnologyIDE Configuration Enhanced C-StatesSerial Port1 Address Serial Port1 IRQSerial Port2 Address Serial Port2 IRQSerial Port4 Address Serial Port4 IRQHardware Health Configuration System Temperature/CPU TemperatureAcpi Settings Video Power Down Mode APM ConfigurationPower Management/APM Hard Disk Drive Power Down Mode Power Button ModeSuspend Time Out Minute Throttle Slow Clock RatioResume On RTC Alarm Advanced Resume Event Controls Resume On RingMPS Configuration MPS RevisionPCI Express Configuration Active State Power-ManagementSB Pcie Ports Configuration USB Configuration USB 2.0 Controller ModeBios Ehci Hand-Off Legacy USB SupportPCI PnP Menu PCI Latency Timer Clear NvramPlug & Play O/S Allocate IRQ to PCI VGAPalette Snooping PCI IDE BusMasterOffBoard PCI/ISA IDE Card IRQ3/4/5/7/9/10/11/14/15Boot Menu Boot Settings Configuration Quick Boot Quiet BootAddOn ROM Display Mode Boot Num-LockHit ‘DEL’ Message Display Wait For ‘F1’ If ErrorBoot Device Priority Removable Drives Lan Boot Settings Configuration Supervisor Password User PasswordChange Supervisor Password Change User PasswordBoot Sector Virus Protection Chipset Menu North Bridge Configuration Dram Frequency Configure Dram Timing by SPDBoot Graphic Adapter Priority Internal Graphics Mode SelectAMI Bios Setup Utility South Bridge Configuration Restore on AC Power Loss Pcie Port ConfigurationUSB Function USB 2.0 ControllerExit Menu Save Changes and ExitDiscard Changes and Exit Discard ChangesLoad Optimal Defaults Load Fail-Safe DefaultsChapter Drivers Installation SystemTouch Screen SpecificationDriver Installation- Windows XP FPC Installation of Drivers PenMount Touch screen Embedded O.SWindows XP Embedded Windows CE.NET Calibration Touch screen