Intel FPC 5084, N270 user manual Disclaimers

Page 2

Disclaimers

This manual has been carefully checked and believed to contain accurate information. Acnodes Corporation assumes no responsibility for any infringements of patents or any third party’s rights, and any liability arising from such use.

ACNODES does not warrant or assume any legal liability or responsibility for the accuracy, completeness or usefulness of any information in this document. ACNODES does not make any commitment to update the information in this manual.

ACNODES reserves the right to change or revise this document and/or product at any time without notice.

No part of this document may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of ACNODES Co., Ltd.

©Copyright 2009 Acnodes

CorporationAll Rights Reserved

July 2009, Version A1

Printed in Taiwan

ii

Image 2
Contents FPC Disclaimers Safety Approvals FCC ComplianceSafety Precautions Trademarks Acknowledgments Table of Contents Drivers Installation Memo General Description Reliable and Stable DesignSpecifications Main CPU BoardSystem Specification 2 I/O SystemFPC Dimensions FPC I/O Outlets Packing List Chapter Hardware Installation CF card InstallationHardware Installation Serial Ports Interface Signal Name Pin Signal EthernetMountings Panel/Wall/Desktop/VESA Panel MountingWall-Mounting Desktop-Mounting Hardware Installation VESA-ARM Mounting Vesa mounting Installation completed FPC Dram Installation FPC Wireless LAN Card Installation FPC Memo Page Starting Navigation KeysMain Menu System Time/DateAdvanced Menu Max Cpuid Value Limit Configure advanced CPU settingsExecute-Disable Bit Capability Hyper Threading TechnologyIDE Configuration Enhanced C-StatesSerial Port2 Address Serial Port1 AddressSerial Port1 IRQ Serial Port2 IRQSerial Port4 Address Serial Port4 IRQHardware Health Configuration System Temperature/CPU TemperatureAcpi Settings Video Power Down Mode APM ConfigurationPower Management/APM Suspend Time Out Minute Hard Disk Drive Power Down ModePower Button Mode Throttle Slow Clock RatioResume On RTC Alarm Advanced Resume Event Controls Resume On RingMPS Configuration MPS RevisionPCI Express Configuration Active State Power-ManagementSB Pcie Ports Configuration Bios Ehci Hand-Off USB ConfigurationUSB 2.0 Controller Mode Legacy USB SupportPCI PnP Menu Plug & Play O/S PCI Latency TimerClear Nvram Allocate IRQ to PCI VGAOffBoard PCI/ISA IDE Card Palette SnoopingPCI IDE BusMaster IRQ3/4/5/7/9/10/11/14/15Boot Menu AddOn ROM Display Mode Boot Settings Configuration Quick BootQuiet Boot Boot Num-LockHit ‘DEL’ Message Display Wait For ‘F1’ If ErrorBoot Device Priority Removable Drives Lan Boot Settings Configuration Change Supervisor Password Supervisor PasswordUser Password Change User PasswordBoot Sector Virus Protection Chipset Menu Boot Graphic Adapter Priority North Bridge Configuration Dram FrequencyConfigure Dram Timing by SPD Internal Graphics Mode SelectAMI Bios Setup Utility South Bridge Configuration USB Function Restore on AC Power LossPcie Port Configuration USB 2.0 ControllerDiscard Changes and Exit Exit MenuSave Changes and Exit Discard ChangesLoad Optimal Defaults Load Fail-Safe DefaultsChapter Drivers Installation SystemTouch Screen SpecificationDriver Installation- Windows XP FPC Installation of Drivers PenMount Touch screen Embedded O.SWindows XP Embedded Windows CE.NET Calibration Touch screen