Intel N270, FPC 5084 user manual Windows CE.NET, Calibration Touch screen

Page 73

FPC 5084 User Manual

4.3.2 Windows CE.NET 6.0

Here are supported onboard devices:

Onboard Multi I/O

USB

PS2 Keyboard and mouse

CRT/LCD display

10/100/1000 base-T Ethernet

Compact Flash

Onboard Audio

Audio

Touch Screen

Calibration Touch screen

In this image we add PenMount Touch drivers and utilities. It is customized for 800 x 600.

Calibration:

1.Click “Calibratyion” on desktop to calibrate touch screen.

2.In the start\programs menu, select “save registry”, thus Calibration data will be saved and effective in next booting.

Installation of Drivers

63

Image 73

Contents FPC Disclaimers FCC Compliance Safety ApprovalsSafety Precautions Trademarks Acknowledgments Table of Contents Drivers Installation Memo Reliable and Stable Design General DescriptionMain CPU Board Specifications2 I/O System System SpecificationFPC Dimensions FPC I/O Outlets Packing List CF card Installation Chapter Hardware InstallationHardware Installation Serial Ports Interface Signal Name Ethernet Pin SignalPanel Mounting Mountings Panel/Wall/Desktop/VESAWall-Mounting Desktop-Mounting Hardware Installation VESA-ARM Mounting Vesa mounting Installation completed FPC Dram Installation FPC Wireless LAN Card Installation FPC Memo Page Navigation Keys StartingSystem Time/Date Main MenuAdvanced Menu Execute-Disable Bit Capability Configure advanced CPU settingsMax Cpuid Value Limit Hyper Threading TechnologyEnhanced C-States IDE ConfigurationSerial Port1 IRQ Serial Port1 AddressSerial Port2 Address Serial Port2 IRQSerial Port4 IRQ Serial Port4 AddressSystem Temperature/CPU Temperature Hardware Health ConfigurationAcpi Settings Power Management/APM APM ConfigurationVideo Power Down Mode Power Button Mode Hard Disk Drive Power Down ModeSuspend Time Out Minute Throttle Slow Clock RatioAdvanced Resume Event Controls Resume On Ring Resume On RTC AlarmMPS Revision MPS ConfigurationActive State Power-Management PCI Express ConfigurationSB Pcie Ports Configuration USB 2.0 Controller Mode USB ConfigurationBios Ehci Hand-Off Legacy USB SupportPCI PnP Menu Clear Nvram PCI Latency TimerPlug & Play O/S Allocate IRQ to PCI VGAPCI IDE BusMaster Palette SnoopingOffBoard PCI/ISA IDE Card IRQ3/4/5/7/9/10/11/14/15Boot Menu Quiet Boot Boot Settings Configuration Quick BootAddOn ROM Display Mode Boot Num-LockBoot Device Priority Wait For ‘F1’ If ErrorHit ‘DEL’ Message Display Removable Drives Lan Boot Settings Configuration User Password Supervisor PasswordChange Supervisor Password Change User PasswordBoot Sector Virus Protection Chipset Menu Configure Dram Timing by SPD North Bridge Configuration Dram FrequencyBoot Graphic Adapter Priority Internal Graphics Mode SelectAMI Bios Setup Utility South Bridge Configuration Pcie Port Configuration Restore on AC Power LossUSB Function USB 2.0 ControllerSave Changes and Exit Exit MenuDiscard Changes and Exit Discard ChangesLoad Fail-Safe Defaults Load Optimal DefaultsSystem Chapter Drivers InstallationDriver Installation- Windows XP SpecificationTouch Screen FPC Installation of Drivers Windows XP Embedded Embedded O.SPenMount Touch screen Calibration Touch screen Windows CE.NET