Intel FPC 5084 Serial Port1 Address, Serial Port1 IRQ, Serial Port2 Address, Serial Port2 IRQ

Page 40

FPC 5084

Serial Port1 Address

This item specifies the base I/O port address and Interrupt Request address of serial port 1. The Optimal setting is 3F8/IRQ4. The Fail-Safe default setting is 3F8.

Serial Port1 IRQ

This item specifies the IRQ used by the serial port 1.

Serial Port2 Address

This item specifies the base I/O port address and Interrupt Request address of serial port 2. The Optimal setting is 2F8/IRQ3. The Fail-Safe setting is 2F8.

Serial Port2 IRQ

This item specifies the IRQ used by the serial port 2.

Serial Port3 Address

This item specifies the base I/O port address and Interrupt Request address of serial port 3.

Serial Port3 IRQ

This item specifies the IRQ used by the serial port 3.

30	AMI BIOS Setup Utility

Image 40

Contents FPC Disclaimers Safety Approvals FCC ComplianceSafety Precautions Trademarks Acknowledgments Table of Contents Drivers Installation Memo General Description Reliable and Stable DesignSpecifications Main CPU BoardSystem Specification 2 I/O SystemFPC Dimensions FPC I/O Outlets Packing List Chapter Hardware Installation CF card InstallationHardware Installation Serial Ports Interface Signal Name Pin Signal EthernetMountings Panel/Wall/Desktop/VESA Panel MountingWall-Mounting Desktop-Mounting Hardware Installation VESA-ARM Mounting Vesa mounting Installation completed FPC Dram Installation FPC Wireless LAN Card Installation FPC Memo Page Starting Navigation KeysMain Menu System Time/Date Advanced Menu Configure advanced CPU settings Execute-Disable Bit CapabilityMax Cpuid Value Limit Hyper Threading TechnologyIDE Configuration Enhanced C-StatesSerial Port1 Address Serial Port1 IRQSerial Port2 Address Serial Port2 IRQSerial Port4 Address Serial Port4 IRQHardware Health Configuration System Temperature/CPU TemperatureAcpi Settings Power Management/APM APM ConfigurationVideo Power Down Mode Hard Disk Drive Power Down Mode Power Button ModeSuspend Time Out Minute Throttle Slow Clock RatioResume On RTC Alarm Advanced Resume Event Controls Resume On RingMPS Configuration MPS RevisionPCI Express Configuration Active State Power-ManagementSB Pcie Ports Configuration USB Configuration USB 2.0 Controller ModeBios Ehci Hand-Off Legacy USB SupportPCI PnP Menu PCI Latency Timer Clear NvramPlug & Play O/S Allocate IRQ to PCI VGAPalette Snooping PCI IDE BusMasterOffBoard PCI/ISA IDE Card IRQ3/4/5/7/9/10/11/14/15Boot Menu Boot Settings Configuration Quick Boot Quiet BootAddOn ROM Display Mode Boot Num-LockBoot Device Priority Wait For ‘F1’ If ErrorHit ‘DEL’ Message Display Removable Drives Lan Boot Settings Configuration Supervisor Password User PasswordChange Supervisor Password Change User PasswordBoot Sector Virus Protection Chipset Menu North Bridge Configuration Dram Frequency Configure Dram Timing by SPDBoot Graphic Adapter Priority Internal Graphics Mode SelectAMI Bios Setup Utility South Bridge Configuration Restore on AC Power Loss Pcie Port ConfigurationUSB Function USB 2.0 ControllerExit Menu Save Changes and ExitDiscard Changes and Exit Discard ChangesLoad Optimal Defaults Load Fail-Safe DefaultsChapter Drivers Installation SystemDriver Installation- Windows XP SpecificationTouch Screen FPC Installation of Drivers Windows XP Embedded Embedded O.SPenMount Touch screen Windows CE.NET Calibration Touch screen