Intel N270, FPC 5084 user manual Enhanced C-States, IDE Configuration

Page 39

FPC 5084 User Manual

Enhanced C-States

This item allows you to enable or disable any available enhanced C-states ( C1E, C2E, C3E, C4E and Hard C4E).

IDE Configuration

You can use this screen to select options for the IDE Configuration, and change the value of the selected option. A description of the selected item appears on the right side of the screen. For items marked with “f”, please press <Enter> for more options.

Primary/Secondary/Third IDE Master/Slave Select one of the hard disk drives to configure IDE devices installed in the system by pressing <Enter> for more options.

SuperIO Configuration

You can use this screen to select options for the SuperIO Configuration, and change the value of the selected option. A description of the selected item appears on the right side of the screen.

AMI BIOS Setup Utility

29

Image 39

Contents FPC Disclaimers FCC Compliance Safety ApprovalsSafety Precautions Trademarks Acknowledgments Table of Contents Drivers Installation Memo Reliable and Stable Design General DescriptionMain CPU Board Specifications2 I/O System System SpecificationFPC Dimensions FPC I/O Outlets Packing List CF card Installation Chapter Hardware InstallationHardware Installation Serial Ports Interface Signal Name Ethernet Pin SignalPanel Mounting Mountings Panel/Wall/Desktop/VESAWall-Mounting Desktop-Mounting Hardware Installation VESA-ARM Mounting Vesa mounting Installation completed FPC Dram Installation FPC Wireless LAN Card Installation FPC Memo Page Navigation Keys StartingSystem Time/Date Main MenuAdvanced Menu Hyper Threading Technology Configure advanced CPU settingsExecute-Disable Bit Capability Max Cpuid Value LimitEnhanced C-States IDE ConfigurationSerial Port2 IRQ Serial Port1 AddressSerial Port1 IRQ Serial Port2 AddressSerial Port4 IRQ Serial Port4 AddressSystem Temperature/CPU Temperature Hardware Health ConfigurationAcpi Settings APM Configuration Power Management/APMVideo Power Down Mode Throttle Slow Clock Ratio Hard Disk Drive Power Down ModePower Button Mode Suspend Time Out MinuteAdvanced Resume Event Controls Resume On Ring Resume On RTC AlarmMPS Revision MPS ConfigurationActive State Power-Management PCI Express ConfigurationSB Pcie Ports Configuration Legacy USB Support USB ConfigurationUSB 2.0 Controller Mode Bios Ehci Hand-OffPCI PnP Menu Allocate IRQ to PCI VGA PCI Latency TimerClear Nvram Plug & Play O/SIRQ3/4/5/7/9/10/11/14/15 Palette SnoopingPCI IDE BusMaster OffBoard PCI/ISA IDE CardBoot Menu Boot Num-Lock Boot Settings Configuration Quick BootQuiet Boot AddOn ROM Display ModeWait For ‘F1’ If Error Boot Device PriorityHit ‘DEL’ Message Display Removable Drives Lan Boot Settings Configuration Change User Password Supervisor PasswordUser Password Change Supervisor PasswordBoot Sector Virus Protection Chipset Menu Internal Graphics Mode Select North Bridge Configuration Dram FrequencyConfigure Dram Timing by SPD Boot Graphic Adapter PriorityAMI Bios Setup Utility South Bridge Configuration USB 2.0 Controller Restore on AC Power LossPcie Port Configuration USB FunctionDiscard Changes Exit MenuSave Changes and Exit Discard Changes and ExitLoad Fail-Safe Defaults Load Optimal DefaultsSystem Chapter Drivers InstallationSpecification Driver Installation- Windows XPTouch Screen FPC Installation of Drivers Embedded O.S Windows XP EmbeddedPenMount Touch screen Calibration Touch screen Windows CE.NET