The Speaker Company ta200 manual Copyright Information

Page 2

Copyright Information

© 2011 TSC Auto ID Technology Co., Ltd,

The copyright in this manual, the software and firmware in the printer described therein are owned by TSC Auto ID Technology Co., Ltd, All rights reserved.

CG Triumvirate is a trademark of Agfa Corporation. CG Triumvirate Bold Condensed font is under license from the Monotype Corporation. Windows is a registered trademark of Microsoft Corporation.

All other trademarks are the property of their respective owners.

Information in this document is subject to change without notice and does not represent a commitment on the part of TSC Auto ID Technology Co. No part of this manual may be reproduced or transmitted in any form or by any means, for any purpose other than the purchaser’s personal use, without the expressed written permission of TSC Auto ID Technology Co.

ii

Image 2
Contents TA200/ TA300 Series Copyright Information Agency Compliance and Approvals IECContents Auto Calibration Start the Diagnostic Tool Printer FunctionCommon Problems Introduction Product IntroductionProduct standard feature 203 dpi 300 dpi Models Product FeaturesPrinter Standard Features Printer Optional Features Product option feature User Dealer Factory OptionsRibbon Specifications General SpecificationsPrint Specifications Print Specifications Dpi modelsMedia Specifications Media Specifications Dpi modelsOperations Overview Unpacking and InspectionPrinter Overview Front ViewInterior View Rear View Setup Setting up the PrinterLoading the Ribbon Page Page  Ribbon loading path Loading the Media Loading the Roll LabelsGap sensor Media guide  Media loading path Loading the Media in Peel-off mode Option Label Liner Loading the Media in Cutter Mode Option External Label Roll Mount Installation Option Roll mount PlatePage Regular Button Functions LED IndicatorLED and Button Functions Power-on Utilities Ribbon and Gap/Black Mark Sensor Calibration2 Gap/Black Mark Calibration, Self-test and Dump Mode  Self-test Gap/black mark sensor intension  Dump mode Printer InitializationParameter Default setting Set Gap Sensor as Media Sensor and Calibrate the Gap SensorSkip AUTO.BAS Diagnostic Tool Start the Diagnostic ToolPrinter Function Function DescriptionCalibrating Media Sensor by Diagnostic Tool Auto CalibrationSetting Ethernet by Diagnostic Utility Option Using USB interface to setup Ethernet interfaceUsing RS-232 interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page Troubleshooting Common ProblemsFlash / Dram Printing position of small Print Head MaintenancePrinter Part Method Interval Date Content Editor Revise HistoryPage No.35, Sec , Ligong 1st Rd., Wujie Township