The Speaker Company ta200 manual Calibrating Media Sensor by Diagnostic Tool, Auto Calibration

Page 38

5.3 Calibrating Media Sensor by Diagnostic Tool

5.3.1Auto Calibration

1.Make sure the media is install ready and print head mechanism is closed. (Please refer to section 3.3.)

Note: The media sensor position is moveable. Please make sure the gap (▽) or black mark is at the location where media gap/black mark will pass through for sensing.

Gap sensor

Black mark sensor

2.Turn on the printer power switch.

3.Open Diagnostic tool and set interface. (The default setting is USB.)

The default interface setting is USB interface. If USB interface is connected with printer, no other settings need to be changed in the interface field.

2

1

4.Click the “Calibrate Sensor” button.

5.Select the media type and click the “Calibrate” button.

1

2

26

Image 38

Contents TA200/ TA300 Series Copyright Information Agency Compliance and Approvals IECContents Auto Calibration Start the Diagnostic Tool Printer FunctionCommon Problems Introduction Product IntroductionProduct standard feature 203 dpi 300 dpi Models Product FeaturesPrinter Standard Features Printer Optional Features Product option feature User Dealer Factory OptionsRibbon Specifications General SpecificationsPrint Specifications Print Specifications Dpi modelsMedia Specifications Media Specifications Dpi modelsOperations Overview Unpacking and InspectionPrinter Overview Front ViewInterior View Rear View Setup Setting up the PrinterLoading the Ribbon Page Page  Ribbon loading path Loading the Media Loading the Roll LabelsGap sensor Media guide  Media loading path Loading the Media in Peel-off mode Option Label Liner Loading the Media in Cutter Mode Option External Label Roll Mount Installation Option Roll mount PlatePage Regular Button Functions LED IndicatorLED and Button Functions Power-on Utilities Ribbon and Gap/Black Mark Sensor Calibration2 Gap/Black Mark Calibration, Self-test and Dump Mode  Self-test Gap/black mark sensor intension  Dump mode Printer InitializationParameter Default setting Set Gap Sensor as Media Sensor and Calibrate the Gap SensorSkip AUTO.BAS Diagnostic Tool Start the Diagnostic ToolPrinter Function Function DescriptionCalibrating Media Sensor by Diagnostic Tool Auto CalibrationSetting Ethernet by Diagnostic Utility Option Using USB interface to setup Ethernet interfaceUsing RS-232 interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page Troubleshooting Common ProblemsFlash / Dram Printing position of small Print Head MaintenancePrinter Part Method Interval Date Content Editor Revise HistoryPage No.35, Sec , Ligong 1st Rd., Wujie Township