The Speaker Company ta200 manual Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor

Page 34

Printer configuration will be restored to defaults as below after initialization.

Parameter	Default setting
Speed	101.6 mm/sec (4 ips) (203DPI)
	76 mm/sec (3 ips) (300DPI)

Density	8

Label Width	4” (101.5 mm)

Label Height	4” (101.5 mm)

Sensor Type	Gap sensor

Gap Setting	0.12” (3.0 mm)

Print Direction	0

Reference Point	0,0 (upper left corner)

Offset	0

Tear Mode	On

Peel off Mode	Off

Cutter Mode	Off

Serial Port Settings	9600 bps, none parity, 8 data bits, 1 stop bit

Code Page	850

Country Code	001

Clear Flash Memory	No

IP Address	DHCP

4.3.4 Set Black Mark Sensor as Media Sensor and Calibrate the Black Mark Sensor

Please follow the steps as below.

1.Turn off the power switch.

2.Hold on the button then turn on the power switch.

3.Release the button when LED turns green/amber after 5 green blinks. (Any green/amber will do during the 5 blinks).

The LED color will be changed as following:

Amber  red (5 blinks)  amber (5 blinks)  green (5 blinks)  green/amber (5 blinks)  red/amber (5 blinks)  solid green

4.3.5Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor

Please follow the steps as below.

1.Turn off the power switch.

2.Hold on the button then turn on the power switch.

22

Image 34

Contents TA200/ TA300 Series Copyright Information Agency Compliance and Approvals IECContents Common Problems Start the Diagnostic Tool Printer FunctionAuto Calibration Introduction Product IntroductionPrinter Standard Features Product FeaturesProduct standard feature 203 dpi 300 dpi Models Printer Optional Features Product option feature User Dealer Factory OptionsRibbon Specifications General SpecificationsPrint Specifications Print Specifications Dpi modelsMedia Specifications Media Specifications Dpi modelsOperations Overview Unpacking and InspectionPrinter Overview Front ViewInterior View Rear View Setup Setting up the PrinterLoading the Ribbon Page Page  Ribbon loading path Loading the Media Loading the Roll LabelsGap sensor Media guide  Media loading path Loading the Media in Peel-off mode Option Label Liner Loading the Media in Cutter Mode Option External Label Roll Mount Installation Option Roll mount PlatePage LED and Button Functions LED IndicatorRegular Button Functions Power-on Utilities Ribbon and Gap/Black Mark Sensor Calibration2 Gap/Black Mark Calibration, Self-test and Dump Mode  Self-test Gap/black mark sensor intension  Dump mode Printer InitializationParameter Default setting Set Gap Sensor as Media Sensor and Calibrate the Gap SensorSkip AUTO.BAS Diagnostic Tool Start the Diagnostic ToolPrinter Function Function DescriptionCalibrating Media Sensor by Diagnostic Tool Auto CalibrationSetting Ethernet by Diagnostic Utility Option Using USB interface to setup Ethernet interfaceUsing RS-232 interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page Troubleshooting Common ProblemsFlash / Dram Printing position of small Printer Part Method Interval MaintenancePrint Head Date Content Editor Revise HistoryPage No.35, Sec , Ligong 1st Rd., Wujie Township