The Speaker Company ta200 manual Using RS-232 interface to setup Ethernet interface

Page 40

5.4.2Using RS-232 interface to setup Ethernet interface

1.Connect the computer and the printer with a RS-232 cable.

2.Turn on the printer power.

3. Start the Diagnostic Utility by double clicks on the

icon.

4.Select “COM” as interface then click on the “Setup” button to setup the serial port baud rate, parity check, data bits, stop bit and flow control parameters.

5.Click on the “Ethernet Setup” button from printer function of Printer Configuration tab to setup the IP address, subnet mask and the gateway for the on board Ethernet.

28

Image 40

Contents TA200/ TA300 Series Copyright Information Agency Compliance and Approvals IECContents Common Problems Start the Diagnostic Tool Printer FunctionAuto Calibration Introduction Product IntroductionPrinter Standard Features Product FeaturesProduct standard feature 203 dpi 300 dpi Models Printer Optional Features Product option feature User Dealer Factory OptionsGeneral Specifications Print SpecificationsRibbon Specifications Print Specifications Dpi modelsMedia Specifications Media Specifications Dpi modelsOperations Overview Unpacking and InspectionPrinter Overview Front ViewInterior View Rear View Setup Setting up the PrinterLoading the Ribbon Page Page  Ribbon loading path Loading the Media Loading the Roll LabelsGap sensor Media guide  Media loading path Loading the Media in Peel-off mode Option Label Liner Loading the Media in Cutter Mode Option External Label Roll Mount Installation Option Roll mount PlatePage LED and Button Functions LED IndicatorRegular Button Functions Power-on Utilities Ribbon and Gap/Black Mark Sensor Calibration2 Gap/Black Mark Calibration, Self-test and Dump Mode  Self-test Gap/black mark sensor intension  Dump mode Printer InitializationParameter Default setting Set Gap Sensor as Media Sensor and Calibrate the Gap SensorSkip AUTO.BAS Diagnostic Tool Start the Diagnostic Tool Printer Function Function DescriptionCalibrating Media Sensor by Diagnostic Tool Auto CalibrationSetting Ethernet by Diagnostic Utility Option Using USB interface to setup Ethernet interfaceUsing RS-232 interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page Troubleshooting Common ProblemsFlash / Dram Printing position of small Printer Part Method Interval MaintenancePrint Head Date Content Editor Revise HistoryPage No.35, Sec , Ligong 1st Rd., Wujie Township