The Speaker Company ta200 manual  Media loading path

Page 22

2

6.Close the print head mechanism by both hands and make sure the latches are engaged securely.

7.Use “Diagnostic Tool” to set the media sensor type and calibrate the selected sensor. (Start the

1“Diagnostic tool”  Select the “Printer Configuration” tab  Click the “Calibrate Sensor” button ) Please refer to section 5.3.

Note:

*Please calibrate the gap/ black mark sensor when changing media.

*Please refer to videos on TSC YouTube or driver CD.

Media loading path

Media bar

Gap sensor

Platen roller

Black mark sensor

Media

Path for outside wound

Path for inside wound

Media guide

10

Image 22

Contents TA200/ TA300 Series Copyright Information Agency Compliance and Approvals IECContents Common Problems Start the Diagnostic Tool Printer FunctionAuto Calibration Introduction Product IntroductionPrinter Standard Features Product FeaturesProduct standard feature 203 dpi 300 dpi Models Printer Optional Features Product option feature User Dealer Factory OptionsRibbon Specifications General SpecificationsPrint Specifications Print Specifications Dpi modelsMedia Specifications Media Specifications Dpi modelsOperations Overview Unpacking and InspectionPrinter Overview Front ViewInterior View Rear View Setup Setting up the PrinterLoading the Ribbon Page Page  Ribbon loading path Loading the Media Loading the Roll LabelsGap sensor Media guide  Media loading path Loading the Media in Peel-off mode Option Label Liner Loading the Media in Cutter Mode Option External Label Roll Mount Installation Option Roll mount PlatePage LED and Button Functions LED IndicatorRegular Button Functions Power-on Utilities Ribbon and Gap/Black Mark Sensor Calibration2 Gap/Black Mark Calibration, Self-test and Dump Mode  Self-test Gap/black mark sensor intension  Dump mode Printer InitializationParameter Default setting Set Gap Sensor as Media Sensor and Calibrate the Gap SensorSkip AUTO.BAS Diagnostic Tool Start the Diagnostic ToolPrinter Function Function DescriptionCalibrating Media Sensor by Diagnostic Tool Auto CalibrationSetting Ethernet by Diagnostic Utility Option Using USB interface to setup Ethernet interfaceUsing RS-232 interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page Troubleshooting Common ProblemsFlash / Dram Printing position of small Printer Part Method Interval MaintenancePrint Head Date Content Editor Revise HistoryPage No.35, Sec , Ligong 1st Rd., Wujie Township