The Speaker Company ta200 manual

Page 42

Users can also change the “Printer Name” by another model name in this fields then click “Set Printer Name” to take effect this change.

Note: After clicking the “Set Printer Name” or “Set IP” button, printer will reset to take effect the settings.

8.Click “Exit” button to exit the Ethernet interface setup and go back to Diagnostic Tool main screen.

Factory Default button

This function will reset the IP, subnet mask, gateway parameters obtained by DHCP and reset the printer name.

Web setup button

Except to use the Diagnostic Utility to setup the printer, you can also explore and configure the printer settings and status or update the firmware with the IE or Firefox web browser. This feature provides a user friendly setup interface and the capability to manage the printer remotely over a network.

30

Image 42

Contents TA200/ TA300 Series Copyright Information Agency Compliance and Approvals IECContents Start the Diagnostic Tool Printer Function Common ProblemsAuto Calibration Introduction Product IntroductionProduct Features Printer Standard FeaturesProduct standard feature 203 dpi 300 dpi Models Printer Optional Features Product option feature User Dealer Factory OptionsRibbon Specifications General SpecificationsPrint Specifications Print Specifications Dpi modelsMedia Specifications Media Specifications Dpi modelsOperations Overview Unpacking and InspectionPrinter Overview Front ViewInterior View Rear View Setup Setting up the PrinterLoading the Ribbon Page Page  Ribbon loading path Loading the Media Loading the Roll LabelsGap sensor Media guide  Media loading path Loading the Media in Peel-off mode Option Label Liner Loading the Media in Cutter Mode Option External Label Roll Mount Installation Option Roll mount PlatePage LED Indicator LED and Button FunctionsRegular Button Functions Power-on Utilities Ribbon and Gap/Black Mark Sensor Calibration2 Gap/Black Mark Calibration, Self-test and Dump Mode  Self-test Gap/black mark sensor intension  Dump mode Printer InitializationParameter Default setting Set Gap Sensor as Media Sensor and Calibrate the Gap SensorSkip AUTO.BAS Diagnostic Tool Start the Diagnostic ToolPrinter Function Function DescriptionCalibrating Media Sensor by Diagnostic Tool Auto CalibrationSetting Ethernet by Diagnostic Utility Option Using USB interface to setup Ethernet interfaceUsing RS-232 interface to setup Ethernet interface Using Ethernet interface to setup Ethernet interface Page Troubleshooting Common ProblemsFlash / Dram Printing position of small Maintenance Printer Part Method IntervalPrint Head Date Content Editor Revise HistoryPage No.35, Sec , Ligong 1st Rd., Wujie Township