MGE UPS Systems 5000 RT Extended Battery EXB, Battery Integration System Kit with Casters

Page 14

Pulsar MX

1.5Extended Battery (EXB)

Pulsar MX RT offers a standard backup time of 5 minutes at full load. To increase backup time, it is possible to connect Pulsar MX EXB RT modules to the UPSs for backup times up to 62 minutes (at full load).

Battery extensions for Pulsar MX RT

Pulsar MX 5000 RT

Pulsar MX 5000 RT:

5 min

Pulsar MX EXB RT

22 min

Pulsar MX EXB RT

41 min

Pulsar MX EXB RT

62 min

Battery Integration System Kit with Casters (86005)

The Battery Integration System is intended for extended backup time configurations to conveniently stack and secure up to 5 modules on the same cart (swivel wheels with brakes, leveling feet, seismic side panels, plates to lock modules, and screws included).

Optional battery extension cable (6 ft/1.8 m)

This extended battery cable will be used instead of the standard battery cable when battery modules are distant from each other (located in two different enclosures, for instance).

1 — 4

Presentation

86-87050-00 A01

Image 14
Contents Pulsar MX Page Pulsar MX Pulsar MX Contents Technical Support and Product Services Return Policy for Repair of Single Phase Products RGAIntroduction Environmental protectionImportant Safety Instructions Symbol Usage This page left blank intentionally 86-87050-00 A01 Tower Position Presentation Standard Positions Rack PositionRear Panels Pulsar MX 5000 RT Pulsar MX EXB RT TransformerRack Mounting Kit Accessories for Rack MountDisplay and Control Panel Optional battery extension cable 6 ft/1.8 m Extended Battery EXBBattery Integration System Kit with Casters Battery extensions for Pulsar MX RTInstallation Unpacking and Contents CheckInternal Battery Connection Battery Start-up Installation in Tower PositionInstallation in Rack Position To adjust the display positionRear bracket system included with rail kits Connection to the communication port by relays Communication PortsConnection to the RS232 or USB communication port Required Protective Devices and Cable Cross-Sections Remote Power Off communication portInstallation of optional Communication card Recommended upstream protectionHardwire Connection of Output Power Cable to UPS Always connect the ground wire firstConnection of Extended Battery Module, UPS, and Transformer Connection to Output ReceptaclesFinal Start-Up Sequence OperationInitial Start-Up UPS Set-UpEquipment is supplied in ECO mode Normal modeECO mode Operating ModesLow battery warning Operation on Battery PowerTransfer to battery power End of backup timeReturn to Normal AC Source UPS Shutdown When AC PresentUPS Shutdown When on Battery Display Organization Access to Maintenance and Personalization DataAccess to Measurements ON/OFF Settings Local SettingsOutput Settings UPS Set-UpBattery Settings MaintenanceUPS Set-Up Using External Software This page left blank intentionally 86-87050-00 A01 Equipment is no longer protected by the UPS TroubleshootingTroubleshooting Leds 21 Displayed details Signification CorrectionPower Module Fault Display Signification CorrectionGet free offers Life Cycle Monitoring LCMDescription LCM warning details SignificationSecure your installation power continuity Reset or disable LCMHot Swapping the Battery Sub-Module MaintenanceHot Swapping the Power Sub-Module Disconnecting the battery sub-module86-87050-00 A01 Technical specifications AppendixMGE Standard Single Phrase Warranty Technical Support and Product Services Pulsar MX Glossary Pulsar MX Page Contact MGE Scenic Avenue, Costa Mesa, California 92626 714