MGE UPS Systems 5000 RT user manual Connection to Output Receptacles

Pulsar MX

2.8 Connection to Output Receptacles

RS-232BATT.NO. RPO

ION:

AUT

		A
	-250V	~,24
200

1. Connect the equipment to the UPS 4 NEMA L6-30R.

If more than one load is connected to the UPS, the total capacity of the loads should not exceed 30 Amps.

2.9 Connection of Extended Battery Module, UPS, and Transformer

53

BATTERY

MODULE

53

BATTERY	UPS MODULE	TRANSFORMER
MODULE	Pulsar MX	MODULE

52

4

TRANSFORMER

INPUT CABLE

11

10

53

13

12

1.Check that the battery circuit breaker(s) (13) is OFF ("0" position).

2.Connect the battery power cable (52) to the connector (4) of the power module and to the connector (12) of the battery module.

3.Connect the battery detection cable (53) to the connector (10) of the power module and to the connector (11) of the battery module.

4.Switch on the battery circuit-breaker(s) (13).

2 — 8 Installation 86-87050-00 A01