MGE UPS Systems 5000 RT user manual Internal Battery Connection Battery Start-up

Page 16

Pulsar MX

2.2 Internal Battery Connection (Battery Start-up)

RS232-BATT.NO. RPO

	ION:
CA	UT

	0V~,	24A
200-25	0V~,
200-25

60

1.Remove the two mounting screws (59) to free the battery disconnect switch (60).

2.Push the battery disconnect switch so that

59you can read “Connected”.

3.Secure the two mounting screws (59).

Input Cable L6-30P

2.3 Installation in Tower Position

Follow steps 1 to 3 in the illustration below to adjust the tower stands for the upright position.

6 inches

17.7 inches

Always keep 6 inches free space behind the UPS rear panel. The distance between the tower stands should be 17.7 inches.

2 — 2

Installation

86-87050-00 A01

Image 16

Contents Pulsar MX Page Pulsar MX Pulsar MX Contents Technical Support and Product Services Return Policy for Repair of Single Phase Products RGAIntroduction Environmental protectionImportant Safety Instructions Symbol Usage This page left blank intentionally 86-87050-00 A01 Presentation Standard PositionsTower Position Rack PositionRear Panels Pulsar MX 5000 RT Pulsar MX EXB RT TransformerDisplay and Control Panel Accessories for Rack MountRack Mounting Kit Extended Battery EXB Battery Integration System Kit with CastersOptional battery extension cable 6 ft/1.8 m Battery extensions for Pulsar MX RTInstallation Unpacking and Contents CheckInternal Battery Connection Battery Start-up Installation in Tower PositionInstallation in Rack Position To adjust the display positionRear bracket system included with rail kits Connection to the RS232 or USB communication port Communication PortsConnection to the communication port by relays Remote Power Off communication port Installation of optional Communication cardRequired Protective Devices and Cable Cross-Sections Recommended upstream protectionHardwire Connection of Output Power Cable to UPS Always connect the ground wire firstConnection of Extended Battery Module, UPS, and Transformer Connection to Output ReceptaclesOperation Initial Start-UpFinal Start-Up Sequence UPS Set-UpNormal mode ECO modeEquipment is supplied in ECO mode Operating ModesOperation on Battery Power Transfer to battery powerLow battery warning End of backup timeUPS Shutdown When on Battery UPS Shutdown When AC PresentReturn to Normal AC Source Access to Measurements Access to Maintenance and Personalization DataDisplay Organization Local Settings Output SettingsON/OFF Settings UPS Set-UpUPS Set-Up Using External Software MaintenanceBattery Settings This page left blank intentionally 86-87050-00 A01 Troubleshooting Troubleshooting Leds 21Equipment is no longer protected by the UPS Displayed details Signification CorrectionPower Module Fault Display Signification CorrectionLife Cycle Monitoring LCM DescriptionGet free offers LCM warning details SignificationSecure your installation power continuity Reset or disable LCMMaintenance Hot Swapping the Power Sub-ModuleHot Swapping the Battery Sub-Module Disconnecting the battery sub-module86-87050-00 A01 Technical specifications AppendixMGE Standard Single Phrase Warranty Technical Support and Product Services Pulsar MX Glossary Pulsar MX Page Contact MGE Scenic Avenue, Costa Mesa, California 92626 714