MGE UPS Systems 5000 RT Operation on Battery Power, Transfer to battery power, End of backup time

Page 25

Installation and User Manual

3.4 Operation on Battery Power

When the Normal AC source is not available, the load continues to be protected by the UPS.

Power is supplied by the battery.

Transfer to battery power

LEDs (20), (21) are ON.

LEDs (31), (32), (34) are green.

The audible alarm beeps every 10 seconds.

The equipment is protected by the UPS and supplied by the battery.

The display indicates the battery remaining backup time.

Low battery warning

LEDs (20), (21) are ON.

LEDs (31), (32), (34) are green.

The audible alarm beeps every 3 seconds.

The remaining battery power is low.

Shut down all applications on the connected equipment because automatic UPS shutdown is imminent.

End of backup time

LED (22) is ON.

LED (34) is red.

The audible alarm beeps continuously.

The equipment is not powered.

The UPS displays "End of backup time Battery low".

86-87050-00 A01

Operation

3 — 3

Image 25
Contents Pulsar MX Page Pulsar MX Pulsar MX Contents Return Policy for Repair of Single Phase Products RGA Technical Support and Product ServicesEnvironmental protection IntroductionImportant Safety Instructions Symbol Usage This page left blank intentionally 86-87050-00 A01 Standard Positions PresentationTower Position Rack PositionPulsar MX 5000 RT Pulsar MX EXB RT Transformer Rear PanelsDisplay and Control Panel Accessories for Rack MountRack Mounting Kit Battery Integration System Kit with Casters Extended Battery EXBOptional battery extension cable 6 ft/1.8 m Battery extensions for Pulsar MX RTUnpacking and Contents Check InstallationInstallation in Tower Position Internal Battery Connection Battery Start-upTo adjust the display position Installation in Rack PositionRear bracket system included with rail kits Connection to the RS232 or USB communication port Communication PortsConnection to the communication port by relays Installation of optional Communication card Remote Power Off communication portRequired Protective Devices and Cable Cross-Sections Recommended upstream protectionAlways connect the ground wire first Hardwire Connection of Output Power Cable to UPSConnection to Output Receptacles Connection of Extended Battery Module, UPS, and TransformerInitial Start-Up OperationFinal Start-Up Sequence UPS Set-UpECO mode Normal modeEquipment is supplied in ECO mode Operating ModesTransfer to battery power Operation on Battery PowerLow battery warning End of backup timeUPS Shutdown When on Battery UPS Shutdown When AC PresentReturn to Normal AC Source Access to Measurements Access to Maintenance and Personalization DataDisplay Organization Output Settings Local SettingsON/OFF Settings UPS Set-UpUPS Set-Up Using External Software MaintenanceBattery Settings This page left blank intentionally 86-87050-00 A01 Troubleshooting Leds 21 TroubleshootingEquipment is no longer protected by the UPS Displayed details Signification CorrectionDisplay Signification Correction Power Module FaultDescription Life Cycle Monitoring LCMGet free offers LCM warning details SignificationReset or disable LCM Secure your installation power continuityHot Swapping the Power Sub-Module MaintenanceHot Swapping the Battery Sub-Module Disconnecting the battery sub-module86-87050-00 A01 Appendix Technical specificationsMGE Standard Single Phrase Warranty Technical Support and Product Services Pulsar MX Glossary Pulsar MX Page Scenic Avenue, Costa Mesa, California 92626 714 Contact MGE