MGE UPS Systems 3000 VA, 2000 Securing and connecting the connection modules, Two screws

Page 16

2.Installation

2.5Securing and connecting the connection modules

Securing the connection modules

1. Insert the connection module in the connector 10 .

10	2. Secure the connection module to the UPS using
10
	the two screws 31 .
31
31

Fault tolerant

Before carrying out any connections, check that the battery circuit breaker 8 is OFF and that the electrical power cord to the AC-power source is disconnected.

Connection of equipment:

Connect the protected equipment directly to the outlets 2 .

2

1Connection to the AC-power source:

29	1. Connect the electrical power cord 29 to the socket 1
	for connection to AC-power source.

2. Connect the other end of the electrical power cord to an AC-power outlet.

Page 16 - 51033211EN/AC

Image 16

Contents Pulsar EXtreme Introduction Foreword Using this documentPictograms Contents Failure of AC input power and operation on battery power Glossary IndexPresentation Pulsar EXtreme rangeTower model Rack modelFault tolerant Hot swap InstallConnection modules Output terminal block with cable clampBack Battery extensions for UPS backup times of 66 minutes OptionsCLA Alarms Battery Load Remaining Control panelCD ROM with Solution Pac and UPS Driver softwares InstallationUnpacking and checks Rack model Installation of the rack version Rack mounting diagram with railsInstallation of the communications-card option Connection to the RS 232 communications port optionalSecuring and connecting the connection modules Connection to the AC-power sourceSecuring the connection modules Two screwsHot swap Always connect the earthing wire firstConnection of equipment to a terminal block Power and equipment connections ON-LINE operating mode OperationStart-up Bargraph indicationsFailure of AC input power and operation on battery power Personalizable function Default setting PersonalizationFunction On / OFF conditions tabBattery tab Personalizable function Default setting OptionsOutput tab By-pass tabConnected equipment is no longer supplied with power ShutdownMaintenance Troubleshooting26 51033211EN/AC Fault-tolerant connection module UPS replacementConnected equipment is again protected by the UPS Hot-swap and Install connection modules Press button 24 and wait 20 seconds Check that LED 21 is on UPS recycling at the end of service life EnvironmentThis product has been designed to respect the environment PackingAppendices GlossaryInstall ON-LINE modeSleep mode Start on battery powerBattery Index34 51033211EN/AC