MGE UPS Systems 3000 VA, 2000 user manual Personalization, Function, On / OFF conditions tab

Page 22

3. Operation

3.5 Personalization

Function

Personalization parameters can be set and modified using the "UPS Driver" software installed on a computer that is connected to the UPS (see section 2.3 Connection to the RS 232 communications port).

Check that the RS 232 cable 25 is correctly connected and that the battery circuit breaker 8 is closed.

"UPS Driver" installation:

1 - Insert the Solution-PacCD-ROM containing the UPS Driver software in the drive of a PC running Windows.

2 - Open the Windows File manager or Explorer and select the CD-ROM drive.

3 - Double-click "\Emb\Index.htm", then "UPS Driver".

Once "UPS Driver" has been installed, UPS parameters can be modified in a window containing a number of tabs, each presenting a set of parameters.

"ON / OFF conditions" tab

Personalizable function	Default setting

Automatic start	Enabled

Cold start (battery power)	Enabled

Forced shutdown	Enabled

Sleep mode	Disabled

UPS ON / OFF via software	Enabled

Page 22 - 51033211EN/AC

Image 22

Contents Pulsar EXtreme Introduction Foreword Using this documentPictograms Contents Failure of AC input power and operation on battery power Glossary IndexTower model PresentationPulsar EXtreme range Rack modelConnection modules Fault tolerantHot swap Install Output terminal block with cable clampBack Battery extensions for UPS backup times of 66 minutes OptionsCLA Alarms Battery Load Remaining Control panelCD ROM with Solution Pac and UPS Driver softwares InstallationUnpacking and checks Rack model Installation of the rack version Rack mounting diagram with railsInstallation of the communications-card option Connection to the RS 232 communications port optionalSecuring the connection modules Securing and connecting the connection modulesConnection to the AC-power source Two screwsHot swap Always connect the earthing wire firstConnection of equipment to a terminal block Power and equipment connections ON-LINE operating mode OperationStart-up Bargraph indicationsFailure of AC input power and operation on battery power Function Personalizable function Default settingPersonalization On / OFF conditions tabOutput tab Battery tabPersonalizable function Default setting Options By-pass tabConnected equipment is no longer supplied with power ShutdownMaintenance Troubleshooting26 51033211EN/AC Fault-tolerant connection module UPS replacementConnected equipment is again protected by the UPS Hot-swap and Install connection modules Press button 24 and wait 20 seconds Check that LED 21 is on This product has been designed to respect the environment UPS recycling at the end of service lifeEnvironment PackingAppendices GlossarySleep mode InstallON-LINE mode Start on battery powerBattery Index34 51033211EN/AC