MGE UPS Systems 3000 VA, 2000 user manual Back

Page 8

1.Presentation

1.3Back

6 Slot for communications-card option.

7 Battery module connector.

8 Battery circuit breaker.

9 Rating plate.

10 Connector for connection modules.

11 RS232 communications port.

Page 8 - 51033211EN/AC

Image 8
Contents Pulsar EXtreme Introduction Pictograms Using this documentForeword Contents Failure of AC input power and operation on battery power Glossary IndexPresentation Pulsar EXtreme rangeTower model Rack modelFault tolerant Hot swap InstallConnection modules Output terminal block with cable clampBack Battery extensions for UPS backup times of 66 minutes OptionsCLA Alarms Battery Load Remaining Control panelUnpacking and checks InstallationCD ROM with Solution Pac and UPS Driver softwares Rack model Installation of the rack version Rack mounting diagram with railsInstallation of the communications-card option Connection to the RS 232 communications port optionalSecuring and connecting the connection modules Connection to the AC-power sourceSecuring the connection modules Two screwsConnection of equipment to a terminal block Always connect the earthing wire firstHot swap Power and equipment connections ON-LINE operating mode OperationStart-up Bargraph indicationsFailure of AC input power and operation on battery power Personalizable function Default setting PersonalizationFunction On / OFF conditions tabBattery tab Personalizable function Default setting OptionsOutput tab By-pass tabConnected equipment is no longer supplied with power ShutdownMaintenance Troubleshooting26 51033211EN/AC Connected equipment is again protected by the UPS UPS replacementFault-tolerant connection module Hot-swap and Install connection modules Press button 24 and wait 20 seconds Check that LED 21 is on UPS recycling at the end of service life EnvironmentThis product has been designed to respect the environment PackingAppendices GlossaryInstall ON-LINE modeSleep mode Start on battery powerBattery Index34 51033211EN/AC