MGE UPS Systems 3000 VA, 2000 Shutdown, Connected equipment is no longer supplied with power

Page 24

3. Operation

3.6 Shutdown

Shutdown of connected equipment

21

Complete shutdown of the UPS

8

1. Press button 24 (return to the OFF position).

The connected equipment is no longer supplied with power, but the battery is maintened charged if AC-power source is present.

If the AC source fails, even though the connected equipment is no longer supplied, the UPS operates on battery power and therefore reduces the available backup time.

1. Press button 24 (return to the OFF position).

The connected equipment is no longer supplied with power.

2.Open the upstream device (OFF position) controlling the supply of AC power to the UPS.

3.Switch the battery circuit breaker(s) 8 to OFF position.

The UPS is now de-energised and the batteries are no longer recharged.

Warning: if the upstream source is not switched off, the UPS remains in operation.

Page 24 - 51033211EN/AC

Image 24

Contents Pulsar EXtreme Introduction Using this document ForewordPictograms Contents Failure of AC input power and operation on battery power Glossary IndexPresentation Pulsar EXtreme rangeTower model Rack modelFault tolerant Hot swap InstallConnection modules Output terminal block with cable clampBack Battery extensions for UPS backup times of 66 minutes OptionsCLA Alarms Battery Load Remaining Control panelInstallation CD ROM with Solution Pac and UPS Driver softwaresUnpacking and checks Rack model Installation of the rack version Rack mounting diagram with railsInstallation of the communications-card option Connection to the RS 232 communications port optionalSecuring and connecting the connection modules Connection to the AC-power sourceSecuring the connection modules Two screwsAlways connect the earthing wire first Hot swapConnection of equipment to a terminal block Power and equipment connections ON-LINE operating mode OperationStart-up Bargraph indicationsFailure of AC input power and operation on battery power Personalizable function Default setting PersonalizationFunction On / OFF conditions tabBattery tab Personalizable function Default setting OptionsOutput tab By-pass tabConnected equipment is no longer supplied with power ShutdownMaintenance Troubleshooting26 51033211EN/AC UPS replacement Fault-tolerant connection moduleConnected equipment is again protected by the UPS Hot-swap and Install connection modules Press button 24 and wait 20 seconds Check that LED 21 is on UPS recycling at the end of service life EnvironmentThis product has been designed to respect the environment PackingAppendices GlossaryInstall ON-LINE modeSleep mode Start on battery powerBattery Index34 51033211EN/AC