MGE UPS Systems 3000 VA, 2000 Out of tolerance, Hot swap, Install, Manual bypass, ON-LINE mode

6. Appendices

Out of tolerance	The AC input source is either absent or its voltage or frequency is outside the
	set limits.
Hot swap	Connection module (with manual bypass) offering a socket for connection
	to the AC-power source and outlets or a terminal block for connection
	to the equipment.
Install	Connection module (with manual bypass) offering terminal blocks
	for connection to the AC-power source and the equipment.
Manual bypass	Rotary switch controlled by the user, used to connect the equipment directly
	to the AC-power source. Transfer of the load to the manual bypass enables
	UPS maintenance or replacement, without interrupting the supply of power
	to the connected equipment.
ON-LINE mode	The normal UPS operating mode, by which the AC-power source supplies
	the UPS, which in turn, following double conversion of the AC power,
	supplies the connected equipment.
Percent load	Ratio between the power drawn by the connected equipment and the total
	power that the UPS can supply.
Personalization	A number of UPS functions can be modified using the "UPS Driver" software
	to better meet the user's needs.
Sleep mode	This function shuts down the UPS after 5 minutes when it operates on
	battery power and no load is detected on the UPS output. The UPS restarts
	automatically as soon as the AC input source is restored.
Start on battery power	This function makes it possible to energize the connected equipment even
	when AC input power is not available (operation exclusively on battery power).
Tolerance for AC-power	The range of frequency supplied by the AC-power source within which
source frequency	the UPS can operate in ON-LINE mode (double conversion).
UPS	Uninterruptible Power Supply.
UPS ON / OFF	It is possible to enable or disable use of UPS ON / OFF controls
via software	by the computer-system protection software.

Page 32 - 51033211EN/AC