MGE UPS Systems 3000 VA, 2000 user manual Contents

Page 4

Contents

1.Presentation

1.1	Pulsar EXtreme range	7
	Tower model	7
	Rack model	7
1.2	Connection modules	8
	Fault tolerant	8
	Hot swap	8
	Install	8
1.3	Back	9
1.4	Options	9
	Transformer for galvanic isolation or earthing arrangement change	9
	Battery extensions for UPS backup times of 66 minutes	9
	CLA module (Long backup time charger) for backup times of 2 to 8 hours	10
1.5	Control panel	10

2.Installation

2.1	Unpacking and checks	12
	"Tower" model	12
	"Rack" model	13
2.2	Installation of the rack version	14
2.3	Connection to the RS 232 communications port (optional)	15
2.4	Installation of the communications-card option	15
2.5	Securing and connecting the connection modules	16
	Securing the connection modules	16
	Fault tolerant	16
	Hot swap	17
	Install	18

3.Operation

3.1	ON-LINE operating mode	19
3.2	Start-up	20
3.3	Bargraph indications	20

Page 4 - 51033211EN/AC

Image 4

Contents Pulsar EXtreme Introduction Foreword Using this documentPictograms Contents Failure of AC input power and operation on battery power Glossary IndexPresentation Pulsar EXtreme rangeTower model Rack modelFault tolerant Hot swap InstallConnection modules Output terminal block with cable clampBack Battery extensions for UPS backup times of 66 minutes OptionsCLA Alarms Battery Load Remaining Control panelCD ROM with Solution Pac and UPS Driver softwares InstallationUnpacking and checks Rack model Installation of the rack version Rack mounting diagram with railsInstallation of the communications-card option Connection to the RS 232 communications port optionalSecuring and connecting the connection modules Connection to the AC-power sourceSecuring the connection modules Two screwsHot swap Always connect the earthing wire firstConnection of equipment to a terminal block Power and equipment connections ON-LINE operating mode OperationStart-up Bargraph indicationsFailure of AC input power and operation on battery power Personalizable function Default setting PersonalizationFunction On / OFF conditions tabBattery tab Personalizable function Default setting OptionsOutput tab By-pass tabConnected equipment is no longer supplied with power ShutdownMaintenance Troubleshooting26 51033211EN/AC Fault-tolerant connection module UPS replacementConnected equipment is again protected by the UPS Hot-swap and Install connection modules Press button 24 and wait 20 seconds Check that LED 21 is on UPS recycling at the end of service life EnvironmentThis product has been designed to respect the environment PackingAppendices GlossaryInstall ON-LINE modeSleep mode Start on battery powerBattery Index34 51033211EN/AC