MGE UPS Systems 2000 Failure of AC input power and operation on battery power, Glossary Index

Page 5

		Contents
3.4 Failure of AC input power and operation on battery power		.................................................... 21
	Transfer to battery power	21
	Threshold for the low-battery shutdown warning	21
	End of backup time	21
	Sleep mode	21
	Return of AC input power	21
3.5	Personalization	22
	Function	22
	"ON / OFF conditions" tab	22
	"Battery" tab	23
	"Output" tab	23
	"By-pass" tab	23
3.6	Shutdown	24
	Shutdown of connected equipment	24
	Complete shutdown of the UPS	24

4.Maintenance

4.1	Troubleshooting	25
4.2	UPS replacement	27
	Fault-tolerant connection module	27
	Hot-swap and Install connection modules	28
5. Environment		30

6.Appendices

6.1	Glossary	31
6.2	Index	33

51033211EN/AC - Page 5

Image 5

Contents Pulsar EXtreme Introduction Pictograms Using this documentForeword Contents Glossary Index Failure of AC input power and operation on battery powerPulsar EXtreme range PresentationTower model Rack modelHot swap Install Fault tolerantConnection modules Output terminal block with cable clampBack Options Battery extensions for UPS backup times of 66 minutesCLA Control panel Alarms Battery Load RemainingUnpacking and checks InstallationCD ROM with Solution Pac and UPS Driver softwares Rack model Rack mounting diagram with rails Installation of the rack versionConnection to the RS 232 communications port optional Installation of the communications-card optionConnection to the AC-power source Securing and connecting the connection modulesSecuring the connection modules Two screwsConnection of equipment to a terminal block Always connect the earthing wire firstHot swap Power and equipment connections Operation ON-LINE operating modeBargraph indications Start-upFailure of AC input power and operation on battery power Personalization Personalizable function Default settingFunction On / OFF conditions tabPersonalizable function Default setting Options Battery tabOutput tab By-pass tabShutdown Connected equipment is no longer supplied with powerTroubleshooting Maintenance26 51033211EN/AC Connected equipment is again protected by the UPS UPS replacementFault-tolerant connection module Hot-swap and Install connection modules Press button 24 and wait 20 seconds Check that LED 21 is on Environment UPS recycling at the end of service lifeThis product has been designed to respect the environment PackingGlossary AppendicesON-LINE mode InstallSleep mode Start on battery powerIndex Battery34 51033211EN/AC