American Power Conversion MatrixTM UPS user manual Table of Contents

Page 2

Table of Contents

1.Introduction

2.Safety

3.Presentation

Isolation Unit (IU)

Electronics Unit (EU)

Battery Pack

4. Installation

Receiving Inspection, Protection Strategies,

Moving the UPS, Placement

Input Voltage Selection

Module Interconnections

Emergency Power Off (EPO) Interface

Start-up

Input Plug Incompatibility

5. Operation

Modes of operation

Display and controls operation

6. UPS Monitoring

Computer interface port

7. Difficulty

Troubleshooting chart

Fault messages

Replacing the Electronics Unit

Replacing or adding Battery Packs

Obtaining service

8.Storing the UPS

9.Specifications

Recharge and Run Times

Image 2

Contents

American Power Conversion MatrixTM UPS User’s ManualTable of Contents Overview Emergency Power Off EPOIntroduction Hot Swappable ModulesRemote Interfaces SafetyDisplay Presentation Isolation Unit IU5a. Nema 5-15R receptacles Electronics Unit EU Rear View of the Electronics UnitBattery Pack Rear ViewProtection Strategies InstallationReceiving Inspection Input Voltage Selection PlacementMoving the UPS Vac Input Configuration Module InterconnectionsTypical installation showing mated battery couplers Emergency Power Off EPO Interface Start-Up Modes of Operation OperationInput Plug Incompatibility On-line mode Sleep ModeStandby mode On-battery modeDisplay and Controls Operation Bypass modeDefault screens Transfer between modes of operationUPS Control menu UPS Status menuUPS Diagnostics menu Page UPS Setup Page Page Password protection UPS TestsInterface Kits PowerChute SoftwareUPS Monitoring Computer Interface Port Difficulty Troubleshooting Chart Replace Electronics Unit EU Fault MessagesUPS requires service Battery status Replacing the Electronics Unit Replacing or Adding Battery Packs Obtaining Service Specifications Storing the UPSPhysical Noise and Surge IsolationEnvironment ApprovalsTypical On-Battery Run Times 10.69 13.13 15.57 18.0111.56