American Power Conversion MatrixTM UPS user manual UPS Setup

Page 21

5.2.6 UPS Setup

The UPS Setup menu allows the user access to sub-menus that show special UPS function choices. Function choices are selected with the Select key. Other sub-menus and function choice confirmation can be accessed by pressing the Ok key. The sub-menus and function choices are described below. All sub-menu screens are shown with the factory set function choice.

Note: Function choice values are subject to change - when necessary, the meaning of new values will be explained in errata sheets.

Image 21

Contents

MatrixTM UPS User’s Manual American Power ConversionTable of Contents Introduction Emergency Power Off EPOOverview Hot Swappable ModulesSafety DisplayRemote Interfaces Isolation Unit IU Presentation5a. Nema 5-15R receptacles Rear View of the Electronics Unit Electronics Unit EURear View Battery PackInstallation Receiving InspectionProtection Strategies Placement Moving the UPSInput Voltage Selection Module Interconnections Vac Input ConfigurationTypical installation showing mated battery couplers Emergency Power Off EPO Interface Start-Up Operation Input Plug IncompatibilityModes of Operation Standby mode Sleep ModeOn-line mode On-battery modeDefault screens Bypass modeDisplay and Controls Operation Transfer between modes of operationUPS Status menu UPS Control menuUPS Diagnostics menu Page UPS Setup Page Page UPS Tests Password protectionPowerChute Software UPS MonitoringInterface Kits Computer Interface Port Difficulty Troubleshooting Chart Fault Messages UPS requires serviceReplace Electronics Unit EU Battery status Replacing the Electronics Unit Replacing or Adding Battery Packs Obtaining Service Storing the UPS SpecificationsEnvironment Noise and Surge IsolationPhysical Approvals10.69 13.13 15.57 18.01 Typical On-Battery Run Times11.56