5-7 Image Guide
To perform the following adjustment, it is necessary to remove both plastic side covers first. See Section
Necessary tools: allen key 3mm, gauge 2mm.
The distance between the upper edge of the Image Guide and the roll surface must be 2±0.5mm (0.0787±0.0196 inch), see figure 37.
1.To adjust the Image Guide, it is necessary to position it in front of the
top roller, onto the two support brackets (see arrow #1).
2. Slide the Image Guide all the way towards the roll; make sure that the front edge of the Guide is under the bolt mounted in the support bracket (see arrow #2).
3. If necessary, loosen the two socket screws (arrows #3), that hold the support bracket, half a turn. Perform this at either side of the machine.
4. Reposition the support brackets until the previously mentioned distance of 2 mm has been achieved.
fig. 37
2 | 3 | 1 |
Thighten the socket screws and reassemble the plastic covers.
33