4-5 Solid State Relay
Necessary tools: medium
Approximate time: 20 minutes.
Note:
To remove the Solid State Relay, it is necessary to perform the Rear Panel disassembly procedure (see Section
Perform the following steps:
1.Loosen all four screws that clamp the wires. They are marked 1 through 4. See figure 16.
2.Bend the wires a bit away from the Solid State Relay.
3.Remove the two M4 bolts that hold the Solid State Relay.
4.Now you can remove the Solid State Relay.
5.When mounting the Relay, make sure that the four clamping screws and the two M4 bolts are tight. Don’t forget the serrated washers that belong under the M4 bolt heads.
fig. 16
Note: make sure, that the relay is mounted in the proper way: the coding on the wires must correspond with the numbers on the relay.
Apply a bit
22