SEAL SM110EN, 44Ultra Laminator Photoelectric Cells, Disassembly reciever or transmitter

4-6 Photoelectric Cells

Note: to perform the following adjustments, it is necessary to remove both plastic side covers first. See

section 4.1: Disassembly / Reassembly plastic side covers.

Necessary tools: small flat head screwdriver, Allen key 3mm

Necessary materials: two tie-wraps (2.5 – 3 mm wide), per Photoelectric Cell.

Approximate time: 10 minutes.

Note: perform the Photoelectric Cells Adjustment procedure once the Photoelectric Cell(s) have been replaced.

The Photoelectric Cells are fitted on the arms of the upper roller. Viewed from the front-side of the machine, the transmitter is mounted at the left-hand side and the reciever is mounted at the right-hand side of the machine.

The difference between the transmitter and the receiver is shown below.

fig. 17

Disassembly reciever or transmitter.

1. With the aid of a small screwdriver, remove the springclip (see figure 18).

fig. 18 fig. 19

2.Cut and discard the two tie-wraps.

3.Pull the connector out of the Photoelectric Cell (see figure 19).

23