Canon DS700 manual Printed Surface is Scratched or Ink Blots

Page 72

Troubleshooting

Printed Surface is Scratched or Ink Blots

Possible Cause

Try This

There are ink blots on

Clean the paper feed roller.

the printed surface.

See “Paper Does Not Feed Properly” on page 68.

 

 

 

 

 

 

 

 

 

 

 

 

There are ink blots on

If the protrusions inside the printer are stained, open the cover of

the back side of the

the printer and then wipe ink off the protrusions using a swab or

printed surface.

the like as shown.

 

 

 

 

 

 

 

 

 

 

 

Important

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Before cleaning, be sure to turned off the printer.

Printed on the back side

Follow the steps described below to clean the inside of the printer.

of the sheet/The roller

1.

Ensure that the printer is turned on.

inside the printer is

2.

Load the Glossy Photo paper (4"×6"/ 101.6×152.4mm paper).

extremely dirty

3.

Hold the RESUME/CANCEL button down and release after the

 

 

POWER lamp flashes five times, then feed the sheet of paper.

 

 

After the cleaning is operated for a few seconds, the paper

 

 

comes out.

 

note

 

If the problem remains after performing, repeat this procedure

 

starting with step 1.

 

If the problem remains, contact a Canon service representative.

 

Important

 

Check that your paper is loaded with the correct print side facing up.

 

 

Inappropriate paper type

Check to see if the paper you are printing on is too thick or curled.

used

See “Print Media to Avoid” on page 18.

 

Note that smudging may occur at the top and bottom edges of the

 

paper when using Borderless Printing.

 

note

 

If this does not solve the problem, set the paper thickness lever on

 

the left. See “Paper Thickness Lever” on page 8.

 

* Replace the paper thickness lever on the right after printing.

70

Page 71 Page 73
Image 72
Page 71 Page 73
Contents Photo Printing Guide Exif Print Contents Troubleshooting IntroductionAppendix Easy Setup Instructions Power CordUnpack the Printer Preparing the Printer Place the printer on a flat surfaceRemove the tape from the printer Tape position is subject to changeInstalling the Print Head Press the lock button, then raise the lock leverRemove the protective cap from the print head Place the print head in the holderInstalling an Ink Tank Lock the print head into place by lowering the leverTake out the ink tank Hold the ink tank as shownPrinter Parts and Their Function PrinterCover Buttons on the Remote Control Supplied power cordPower Button Move to the left if ink smudges or the printedSettings Button Printer Parts and Their Function Search ButtonCopies +- Buttons FeetCLASS1 LED Product Menu Screen Page Preparation When Using the Printer with the TV „ Connecting to TVCheck the following before connecting the printer to the TV Displaying a Photo on TV„ Turning off TV and the printer Connect to TVTurn on TV and the printer Check the following before turning off TV and the printerUsing a Memory Card „ Memory Cards Supported by this printerSupported memory cards are as follows Supports„ Inserting a Memory Card Insert only a single type of memory cardTurn on For xD-Picture Card, use the compliant adapter Turn onCard eject button Indicator lamp „ Removing a Memory CardIf you use other cards Loading Paper „ Print Media to Avoid„ Loading the Print Media Turn on the printerPrepare to load paper Load the paper101.6 × 152.4mm Photo stickers ×6 paper „ Media Types for Card Direct Printing Photo Paper Pro 101.6×152.4 mm ×6 up to 20 sheets101.6×152.4 mm Photo Paper Plus Glossy ×6 up to 20 sheets Paper ×6 up to 20 sheets Credit CardEnjoy Photos on TV and Printing -Basic Viewing and Printing from the TV Overview„ Viewing Each Photo on TV and Printing-Photo Gallery Select Photo Gallery Select the photo to printEnjoy Photos on TV and Printing -Basic Menu Screen Use the WX buttons to selectConfirm the settings Start printingConfirm the Page size and Media type Press the Copies +/CopiesPrepare to print Select Photo PrintPhoto Print Press the OK buttonCancel all Specify the number of copies to printUse the Copies +/Copies PreviousEnjoy Photos on TV and Printing -Advanced Selecting Various Print Option-Print Studio„ Specifying the Layout Photo×2 Photo×4 Photo×8Select Layout print Specify the layoutSelect the paste method Paste all„ Printing Stickers from a Favorite Photo Paste photos one by oneStickers ×16 Select Sticker print „ Printing All Photos Select Print allYou can print all photos saved on a memory card „ Printing a Photo List-Print Index Select Print indexSelect Dpof print Handy Functions and Settings „ Specifying the Paper and Other SettingsPress Settings button Settings screen is displayedBorderless print Prints on the whole paper without a borderPrints with a border Date print Prints the date the photo was taken„ Searching for Photos with the Shooting Date-Search Press the Search buttonSpecify the target range Press the button„ Setting the Date Display Format Select Tool Box from the menuSelect Date format You can change the format of data printing„ Changing the Language Displayed Select a language for displayYou can change the language displayed on TV „ Resetting All Settings Use the button to select Yes and then press the buttonConnecting to a Digital Camera Printing Photographs Directly from a Digital CameraPage „ Confirming or Changing the Camera Settings About the Settings Explained BelowDirect Printing from PictBridge-compatible Digital Cameras Card SizeAbout Layout Paper type Photo„ Media Types for Digital Camera Card #1 Card #2 Card #3Setting the Media Type, Page Size, and Layout „ Displaying and Setting the Infrared print ScreenPrepare settings Printing Photos with Infrared Compatible Mobile Phones„ Other Setting Items Select Infrared printSize Sticker Performing Infrared Printing „ Printing a Photo with a Mobile Phone and the PrinterStart Infrared Communication Turn on the printer Load the paper See Loading Paper on„ Printing a Photo by Displaying it on TV Display a photo taken with a mobile phone on TVDisplay Photo received via infrared screen is displayed Start Printing Installing the Printer Driver „ Installing the Printer Driver-WindowsPrinting with the computer Prepare the PrinterClick Easy Install Installation will beginRead the License Agreement, then click Yes to continue „ Installing the Printer Driver-Macintosh When the Installation Results window appears, click OKNext For U.S. customer onlySoftware installation is complete Software installation will startDouble-clickSELPHY DS700 xxx.pkg Double-click the Memory Card Utility folderInstallation Double-clickMemory Card Utility 300.mpkgHow to View the User’s Guide „ How to View the User’s Guide-Windows„ How to View the User’s Guide-Macintosh „ User’s Guide Table of ContentsPrinting Maintenance Print Head Cleaning onPrint Head Deep Cleaning on Printing the Nozzle Check Pattern onWhen no white stripes appear When White stripes appear„ Printing the Nozzle Check Pattern Print the Nozzle Check Pattern„ Print Head Cleaning Start Print Head CleaningConnect TV to the printer and turn them on „ Print Head Deep Cleaning Start Print Head Deep Cleaning„ Aligning the Print Head Print the PatternAlign the Print Head Replacing an Ink Tank „ Replacing an Ink TankOpen the cover Ink tank BCI-16 ColorPrepare a replacement ink tank Remove the empty ink tankInsert the ink tank Print head holder moves to the right„ Resetting the Ink Counter Reset the ink counterTo reset the ink counter from Tool Box „ How Low Ink Warning Setting Works Troubleshooting Nothing is Displayed on TV/Image is PoorRemote Control is not Working Message is Displayed on TVError code Select Tool Box and then press the OK buttonSelect Off and then press the OK button Handling Error Messages Paper Does Not Feed Properly Ink tank is not installed Cleaning onMedia type is not Print head is misalignedPrinted Surface is Scratched or Ink Blots Select Ink drying wait time Select Long or Longer and then press the OK buttonPrinting DownIts peripheral components PhoneCannot Print Properly from the Digital Camera Install a print head. See Installing the Print Head on Defective. Contact a Canon service representativeService representative as early as possible Printer errorCannot Install the Printer Driver Click Start Over on the InstallationFailure screen Specifications AppendixCamera Direct Print Safety Precautions Cleaning the printerAppendix Regulatory Information „ Color Printer Model K10248 DS700For 220-240V, 50/60Hz model „ Remote Control K30240 RC-10 „ Canadian Radio Interference RegulationsIndex IndexPhoto Print Printing a Photo by Displaying it on TV Xxxxxx Canon INC.2004
Top Page Image Contents