Troubleshooting
Camera Error Message | Try This |
Printer in use/Printer | • Photos are being printed from the computer. |
warming up | Wait until printing ends. The printer automatically starts printing |
| the photos from the camera after completing the current |
| printing. |
| • Wait until |
| printing automatically. |
|
|
No paper/Paper error | Load the paper, and select Continue*1 in the display on your |
| camera. |
|
|
Paper Jam | Select Stop in the display on your camera to stop printing. |
| Remove the jammed paper, load new paper, and press the |
| RESUME/CANCEL button on the printer and retry printing. |
|
|
Printer cover open | Close the cover on the printer. |
|
|
No print head | The print head is defective or not installed. (The POWER lamp on |
| the printer flashes five times.) |
| Install a print head. See “Installing the Print Head” on page 5. |
| If the print head has already been installed, press the POWER |
| button to turn off the printer, and press the POWER button again to |
| turn on the printer. If the same error occurs, the print head may be |
| defective. Contact a Canon service representative. |
|
|
Waste tank (ink | The printer has a |
absorber*2) full | during print head cleaning. This error message indicates that the |
| waste ink absorber is nearly full. |
| You can continue printing for a while by selecting Continue*1 in |
| the display on your camera. |
| However, because printing is disabled once the waste ink absorber |
| becomes completely full, you are recommended to contact a Canon |
| service representative as early as possible. |
|
|
No Ink | Install an ink tank. Be sure to press the PUSH mark on the ink tank |
| to ensure it is firmly seated. |
|
|
Printer error | An error requiring servicing might have occurred (the POWER lamp |
| on the printer flashes alternately orange and green). |
| Select Stop in the display on your camera to stop printing. |
| Disconnect the cable between the printer and the camera, turn off |
| the printer, and unplug the power cord of the printer from the |
| power supply. After a while, plug the power cord of the printer back |
| in, turn on the printer, and then reconnect the camera to the |
| printer. |
| If the same error occurs, contact a Canon service representative. |
|
|
*1: To resume printing, you can press the RESUME/CANCEL button on the printer instead of selecting Continue.
*2: The waste ink absorber absorbs ink used at cleaning. Check the printer for proper operation.
74