4 SETUP FLOW
Default Setting Check
This section describes the items to be set before using this equipment through a network. Check if the following setups have been done:
Item | Description/Reference |
|
|
Setting the department code | The department codes must be set to enable a network printing on a |
| department basis. |
| Reference: Operator’s Manual for Copying Functions |
| Chapter 5 “CHANGING EQUIPMENT’S SETTINGS” |
| “Department Code” |
|
|
Setting the paper size for | Check if the paper size of each drawer of this equipment is specified |
each drawer | prior to network printing. |
| Reference: Operator’s Manual for Copying Functions |
| Chapter 5 “CHANGING EQUIPMENT’S SETTINGS” |
| “Paper Size Setting” |
|
|
Setting the device settings | Check if the device settings are made prior to network printing. |
| Reference: Setup Guide for Printing Functions |
| Chapter 10 “TopAccess ADMINISTRATION TAB PAGE- |
| SETUP MENU” |
| “Setting up Device Settings” |
| “Setting the device settings” |
|
|
Setting the terminal ID | If the Fax Kit is installed, specify the terminal ID to identify the Fax termi- |
| nal information. |
| Reference: Operator’s Manual for Facsimile Functions |
| Chapter 5 "ENTERING VARIOUS FUNCTIONS"(??) |
| “Terminal ID Entry” |
|
|
32 Default Setting Check