D-Link DVG-6008S Static IP Settings Function Command Select a Static IP, IP address Settings

13

IP Configuration Settings—Setting IP Configuration of WAN Port

Static IP Settings

NOTE: Complete static IP settings should include a static IP (Option 1 under114), IP address (111), Subnet Mask (112), and Default Gateway (113). Please contact your local Internet Service Provider (ISP) if you have any questions.

Function	Command
Select a Static IP	After entering IVR mode, dial 114.
	After hearing “Enter value”, dial 1 (to select static IP)
IP address Settings	After entering IVR mode, dial 111. After hearing “Enter value”, enter your IP
	address, followed by “#”.
	Example: If the IP address is 192.168.1.200, dial 192*168*1*200#.
Subnet Mask Settings	After entering IVR mode, dial 112. After hearing “Enter value”, enter your
	subnet mask, followed by “#”.
	Example: If the mask value is 255.255.255.0, dial 255*255*255*0#.
Default Gateway Settings	After entering IVR mode, dial 113. After hearing “Enter value”, enter your
	default gateway’s IP address, followed by “#”.
	Example: If the Default Gateway is 192.168.1.254, dial 192*168*1*254#.
Save Settings and Restart	To save settings, dial 509 (Save Settings). After hearing “one”, dial 118 to
	restart the system. Wait for about 40 seconds for the system to restart, and
	then enter 101 to check if the IP address is retained. If the IP address is not
	repeated, it indicates that Gateway has not been properly connected,
	please check if the cable connection, account, or password are correct.

Dynamic IP (DHCP) Settings

After entering IVR mode, dial 114.

After hearing “Enter value”, dial 2 (to select DHCP).

Saving settings –press 509 (Save Settings). After hearing “one”, dial 118 to restart the system. After the system is restarted, press 101 to check if the IP address is retained.

If the system does not repeat the IP address, it indicates Gateway has not been properly connected to the Internet. Please check the cable connection.