D-Link DVG-6008S user manual Nat/Ddns, NAT Traversal

Page 26

NAT/DDNS

NAT Traversal

If a Gateway is set up under an IP sharing setting, you can select either the NAT or STUN protocol.

NAT Public IP: The IP address used by the gateway should be a virtual address. Further more, users must set the Virtual Server Mapping in the NAT Server (A virtual server is defined as a Service Port, and all requests to this port will be redirected to this specified the server IP address).

The default port is listed below: Listen Port (UDP): 5060

RTP Starting Port (UDP): 9000~9015 (Listen Port used for telephone communication).

Http Port (TCP): 80

NAT IP/Domain: Enter the NAT Server IP address (Real External IP address of NAT Server) then fill in the URL (Uniform Resource Locator). If using DDNS, please refer to the next setting item

Enable STUN Client: Using STUN protocol prevents problems with setting the IP sharing function, but some NAT do not support this protocol.

STUN Server IP/Domain and Port: Enter the STUN server IP address and Listen Port number. You can set 2 STUN server spread by semicolon.

Enable UPnP Control Point: To enable the gateway’s IP traffic to pass through a NAT server. This function only works when the NAT server supports UPnP and has it enabled.

Image 26

Contents DVG-6008S Voip Gateway Page Contents Advanced Feature IP Sharing Functions Coding PrincipleIntroduction Product OverviewHardware Description Front Panel Rear Panel DVG-6008S ModelGateway in a NAT network Network InterfaceGateway Assigned with a Public IP Address Page Telephone Interface Description Integrating Line Ports with PBXIVR Interactive Voice Response Basic Settings of a GatewayPreparation Instructions Save SettingsSoftware Upgrades To inquire about current Gateway’s WAN Port IP addressIVR Functions Table Function Code Description Example Function Code Description Example Subnet Mask Settings Static IP Settings Function Command Select a Static IPIP address Settings Default Gateway SettingsRecorded Voice File Adsl PPPoE SettingsPPPoE Account Settings Select a PPPoEPPPoE Character Conversion Table Network Settings WAN InstructionsPage Setting Static IP IP Configuration Setting WAN PortSetting Dynamic IP Dhcp Adsl PPPoE SettingsClone MAC DNS SettingsBigPond for Australia use only Using Phone Books Manager LAN IP/Subnet mask Network Settings LANLAN interface mode※ Dhcp Settings LAN QoS※ QoS SettingsWAN QoS NAT/DDNS NAT TraversalDdns Example Telephony SettingsPrefix Number Rules For exampleHotline Functions Example Description SIP 164 System FXO Representative number registers to Proxy Each line registers to Proxy independentlyCalling Features Advanced Options Line Settings Fax Settings CodecPage Digit Map Phone Book Speed DialACL for Management CDR SettingsCaller Filter Language Transit Call ControlLong-Distance Control Table Long Distance Exception TableUDT Detection CPT/Cadence SettingsBusy Tone Cadence Measurement CPT parameters TableDetailed description is given below Direct Connection to Pstn Connected to a PBX Extension Line Page Save Settings Filling in the CPT TableSystem Information Ping Test RTP Packet SummaryStun Inquiry Backup/Restore SnmpProvision Settings System Operations Save SettingsSoftware Upgrade LogoutIP Sharing Functions Select TCP/IP, and then click Properties Page Instruction Dialed Number Processing FlowEnd Static Route※ RIPRouting Information Protocol ※Port filtering IP FilteringMAC Filtering Virtual ServerURL Filter※ Special Applications※DoS Prevention Settings※