D-Link DVG-6008S user manual Long-Distance Control Table, Long Distance Exception Table

Page 45

43

Long-Distance Control Table

This table controls the level of authority of an outgoing call through FXO.

If Level 0 (the highest level) is set to prohibit dialing any number started with prefix 0204, then any level below 0 (including Levels 1 to 5) is also prohibited.

If Level 1 is set to prohibit dialing any number with prefix 0, then any level below 1 (including Levels 2 to 5) is also prohibited. Since Level 0 is not restricted to any prefix, therefore at level 0 users can dial a number with the prefix 0.

Note: Downward Restriction —If the users at a higher level cannot dial a number with a certain prefix, then users at lowers level also cannot dial a number with the same prefix.

Long Distance Exception Table

This table handles any exceptions to the long-distance call table.

According to the Long Distance Control Table, users at Level 0 are prohibited to dial a number with the prefix 0204. But, if the number 020488988 is set in the Exception Table as above, then users could then dial this number.

Note: Upward Opening —If the users at a lower level can dial a number with a certain prefix, then the users at higher levels can also dial a number with the same prefix.

Image 45

Contents DVG-6008S Voip Gateway Page Contents IP Sharing Functions Coding Principle Advanced FeatureProduct Overview IntroductionHardware Description Front Panel DVG-6008S Model Rear PanelNetwork Interface Gateway Assigned with a Public IP AddressGateway in a NAT network Page Integrating Line Ports with PBX Telephone Interface DescriptionBasic Settings of a Gateway PreparationIVR Interactive Voice Response Software Upgrades Save SettingsInstructions To inquire about current Gateway’s WAN Port IP addressIVR Functions Table Function Code Description Example Function Code Description Example IP address Settings Static IP Settings Function Command Select a Static IPSubnet Mask Settings Default Gateway SettingsPPPoE Account Settings Adsl PPPoE SettingsRecorded Voice File Select a PPPoEPPPoE Character Conversion Table Instructions Network Settings WANPage Setting Dynamic IP Dhcp IP Configuration Setting WAN PortSetting Static IP Adsl PPPoE SettingsDNS Settings BigPond for Australia use onlyClone MAC Using Phone Books Manager Network Settings LAN LAN interface mode※LAN IP/Subnet mask Dhcp Settings QoS Settings WAN QoSLAN QoS※ NAT Traversal NAT/DDNSDdns Prefix Number Rules Telephony SettingsExample For exampleHotline Functions Example Description SIP 164 System Each line registers to Proxy independently FXO Representative number registers to ProxyCalling Features Advanced Options Line Settings Codec Fax SettingsPage Digit Map Speed Dial Phone BookCDR Settings Caller FilterACL for Management Transit Call Control LanguageLong Distance Exception Table Long-Distance Control TableBusy Tone Cadence Measurement CPT/Cadence SettingsUDT Detection CPT parameters TableDetailed description is given below Direct Connection to Pstn Connected to a PBX Extension Line Page Filling in the CPT Table Save SettingsSystem Information RTP Packet Summary Stun InquiryPing Test Snmp Backup/RestoreSystem Operations Save Settings Provision SettingsLogout Software UpgradeIP Sharing Functions Select TCP/IP, and then click Properties Page Dialed Number Processing Flow InstructionEnd RIPRouting Information Protocol ※ Static Route※IP Filtering Port filteringVirtual Server MAC FilteringSpecial Applications※ URL Filter※DoS Prevention Settings※