D-Link DVG-6008S user manual Hotline Functions

Page 29

27

FXO Caller ID Detection: To detect the Caller ID delivered from PSTN to the FXO port. While enabled, the Caller ID detected on the FXO port will be send to the SIP Proxy Server on dialing out calls.

Detection Level: The gain volume occurs on Caller ID detection.

Note: You have to enable “Wait for Caller ID before FXO / Trunk pick up” to ensure Caller ID is detected correctly.

FSK Caller ID Type: Select FSK type. In most cases, Bellcore is preferred in North America and ETSI in Europe.

Anonymous Caller ID (CLIR): When enabled, the caller’s phone set will not display your number.

Note: If you register the gateway to a Proxy, you may be unable to make a call. This is due to the fact that the gateway doesn’t send the number for authorization.

Anonymous Transit in W/O Caller ID: FXO won’t detect caller ID, and the gateway will dial out with anonymous caller identification. If the call needs caller ID to be identified for Proxy, Proxy will reject this call without caller id.

Trunk Incoming Prompt Voice: Select the greeting (must use the IVR 132 function to record a voice file) when FXO receives an inbound call.

Upload Greeting: It is able to upload the recorded voice file. The format must be G.723.

FXO Hunting VoIP call in option: To set FXO dial-out mode by using the default setting or waiting caller to dial out when the VoIP call calls FXO hunting number.

FXO Hunting Default Dial-Out: To set FXO default dial-out number.

FXO Line VoIP call in options: To set FXO dial-out mode when the VoIP call indicates the FXO extension number.

Enable: Enable a line; if some lines are not used, disable them (Pause Function) to avoid unnecessary waiting when an incoming call is diverting to this line.

Hotline Functions

Image 29

Contents DVG-6008S Voip Gateway Page Contents IP Sharing Functions Coding Principle Advanced FeatureProduct Overview IntroductionHardware Description Front Panel DVG-6008S Model Rear PanelGateway in a NAT network Network InterfaceGateway Assigned with a Public IP Address Page Integrating Line Ports with PBX Telephone Interface DescriptionIVR Interactive Voice Response Basic Settings of a GatewayPreparation Software Upgrades Save SettingsInstructions To inquire about current Gateway’s WAN Port IP addressIVR Functions Table Function Code Description Example Function Code Description Example IP address Settings Static IP Settings Function Command Select a Static IPSubnet Mask Settings Default Gateway SettingsPPPoE Account Settings Adsl PPPoE SettingsRecorded Voice File Select a PPPoEPPPoE Character Conversion Table Instructions Network Settings WANPage Setting Dynamic IP Dhcp IP Configuration Setting WAN PortSetting Static IP Adsl PPPoE SettingsClone MAC DNS SettingsBigPond for Australia use only Using Phone Books Manager LAN IP/Subnet mask Network Settings LANLAN interface mode※ Dhcp Settings LAN QoS※ QoS SettingsWAN QoS NAT Traversal NAT/DDNSDdns Prefix Number Rules Telephony SettingsExample For exampleHotline Functions Example Description SIP 164 System Each line registers to Proxy independently FXO Representative number registers to ProxyCalling Features Advanced Options Line Settings Codec Fax SettingsPage Digit Map Speed Dial Phone BookACL for Management CDR SettingsCaller Filter Transit Call Control LanguageLong Distance Exception Table Long-Distance Control TableBusy Tone Cadence Measurement CPT/Cadence SettingsUDT Detection CPT parameters TableDetailed description is given below Direct Connection to Pstn Connected to a PBX Extension Line Page Filling in the CPT Table Save SettingsSystem Information Ping Test RTP Packet SummaryStun Inquiry Snmp Backup/RestoreSystem Operations Save Settings Provision SettingsLogout Software UpgradeIP Sharing Functions Select TCP/IP, and then click Properties Page Dialed Number Processing Flow InstructionEnd RIPRouting Information Protocol ※ Static Route※IP Filtering Port filteringVirtual Server MAC FilteringSpecial Applications※ URL Filter※DoS Prevention Settings※