NETGEAR CG3000Dv2 user manual FCC Caution

Page 58

NETGEAR DOCSIS 3.0 N450 Wi-Fi Data Gateway

FCC Radio Frequency Interference Warnings & Instructions

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following methods:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and the receiver.

•Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

FCC Caution

•Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

•This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

•For product available in the USA and Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.

•Pour les produits disponibles aux États-Unis / Canada du marché, seul le canal 1 à 11 peuvent être exploités. Sélection d'autres canaux n'est pas possible.

•This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.

•Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement en association avec une autre antenne ou transmetteur.

Canadian Department of Communications Radio Interference Regulations

This digital apparatus (NETGEAR DOCSIS 3.0 N450 Wi-Fi Data Gateway) does not exceed the Class B limits for radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications.

This Class [B] digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada

Industry Canada

This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Caution:

The device for the band 5150-5250 MHz is only for indoor usage to reduce po-tential for harmful interference to co-channel mobile satellite systems.

High power radars are allocated as primary users (meaning they have priority) of 5250-5350 MHz and 5650-5850 MHz and these radars could cause interference and/or damage to LE-LAN devices.

Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable.

Notification of Compliance

58

Page 57 Page 59
Image 58
Page 57 Page 59
Contents August 2013 East Plumeria Drive San Jose, CA USARevision History Contents Appendix a Supplemental Information Connecting to the Internet Gateway Front Panel DescriptionSecurity, see the Use Push N Connect WPS Wireless Setup on Gateway Rear Panel Gateway rear panelWireless Performance and Gateway Location LabelLog In to Your Gateway  To log in to the gatewayView Basic Settings  To view or configure basic settingsConfiguring Your Wireless Network Set Up Your Wireless Network  To view or configure the wireless settingsNetgear Docsis 3.0 N450 Wi-Fi Data Gateway Use Push N Connect WPS Wireless Setup Netgear Docsis 3.0 N450 Wi-Fi Data Gateway Add a Client Using a PIN  To add a wireless device to your gateway using a PINSet Up Wi-Fi Multimedia  To set up Wi-Fi MultimediaChange the Password  To change the passwordPage Filtering Content View Denial of Service DoS Attack Logs  To receive notification of attacks by email To block access to sites containing certain words Limit Internet Site AccessClick Remove Keyword  To block access to certain domains Allow Unrestricted Access Disable Gateway Features To disable specific NAT ALG Status features  To disable specific web featuresFeature Description Netgear Docsis 3.0 N450 Wi-Fi Data Gateway Maintaining Your Network  To view the gateway status View the Gateway StatusModem field Description  To view the gateway’s initialization procedure Back Up and Restore Your SettingsView the Connection Status  To restore the backup settings  To back up the settingsView the Event Log  To view the event log Run the Diagnostic Utilities To run a ping test Click Start Test Traceroute Utility  To run a traceroute testAdvanced Settings  To configure advanced wireless settings Advanced Wireless SettingsAdvanced Wireless Settings Description MAC Filtering  To stop blocking a computer  To remove a computer from the listIP Filtering  To set up IP filtering To delete a device from the IP Filter List Port Blocking  To configure port blockingPort Forwarding Netgear Docsis 3.0 N450 Wi-Fi Data Gateway  To configure port triggering Port TriggeringDMZ Host  To set up a DMZ hostSelect the Respond to Ping on WAN Port check box LAN IP Setup  To configure LAN IP settings To reserve an IP address for Dhcp LAN SwitchReserve an IP Address for Dhcp Use Click Delete To disable a LAN port Configure Universal Plug and Play UPnP To configure the switch ports  To configure UPnP To enable NTP Set Networking ProtocolsRemove USB Devices Enable Network Address Translation To disable NAT  To remove a USB deviceTroubleshooting See Troubleshoot a TCP/IP Network Using a Ping Utility onConnect to the Gateway’s Main Menu Basic FunctionsLED Behavior Action Troubleshoot a TCP/IP Network Using a Ping Utility Troubleshoot the ISP ConnectionTest the LAN Path to Your Gateway PingNetgear Docsis 3.0 N450 Wi-Fi Data Gateway Supplemental Information Factory Default Settings Feature Parameter DefaultTechnical Specifications Component SpecificationNetgear Docsis 3.0 N450 Wi-Fi Data Gateway Notification of Compliance Regulatory Compliance InformationFCC Caution Avertissement
Top Page Image Contents