NETGEAR CG3000Dv2 Enable Network Address Translation, Remove USB Devices,  To disable NAT

Page 47

NETGEAR DOCSIS 3.0 N450 Wi-Fi Data Gateway

Enable Network Address Translation

Network Address Translation (NAT) provides one-to-many translation of IP addresses between devices. This means that your network presents only one IP address to the Internet, and outside users cannot directly address any of your local computers. Enable NAT to allow multiple computers on your network to access the Internet using a single public IP address. NAT is enabled by default.

To disable NAT:

1.In the main menu, under Advanced, select NAT.

2.Deselect the Turn NAT On box.

3.Click Apply.

Remove USB Devices

To remove a USB device:

1.In the main menu, under USB Storage, select Basic Settings.

2.Click Safely Remove USB Device.

Advanced Settings

47

Image 47

Contents USA August 2013 East Plumeria Drive San Jose, CARevision History Contents Appendix a Supplemental Information Connecting to the Internet Description Gateway Front PanelSecurity, see the Use Push N Connect WPS Wireless Setup on Gateway rear panel Gateway Rear PanelLabel Wireless Performance and Gateway Location To log in to the gateway Log In to Your Gateway To view or configure basic settings View Basic SettingsConfiguring Your Wireless Network  To view or configure the wireless settings Set Up Your Wireless NetworkNetgear Docsis 3.0 N450 Wi-Fi Data Gateway Use Push N Connect WPS Wireless Setup Netgear Docsis 3.0 N450 Wi-Fi Data Gateway  To add a wireless device to your gateway using a PIN Add a Client Using a PIN To set up Wi-Fi Multimedia Set Up Wi-Fi Multimedia To change the password Change the PasswordPage Filtering Content  To receive notification of attacks by email View Denial of Service DoS Attack LogsClick Remove Keyword  To block access to certain domains Limit Internet Site Access To block access to sites containing certain words Disable Gateway Features Allow Unrestricted AccessFeature Description  To disable specific web features To disable specific NAT ALG Status features Netgear Docsis 3.0 N450 Wi-Fi Data Gateway Maintaining Your Network Modem field Description View the Gateway Status To view the gateway status View the Connection Status Back Up and Restore Your Settings To view the gateway’s initialization procedure View the Event Log  To back up the settings To restore the backup settings  To run a ping test Run the Diagnostic Utilities To view the event log Click Start Test  To run a traceroute test Traceroute UtilityAdvanced Settings Advanced Wireless Settings Description Advanced Wireless Settings To configure advanced wireless settings MAC Filtering  To remove a computer from the list  To stop blocking a computer To delete a device from the IP Filter List  To set up IP filteringIP Filtering Port Forwarding  To configure port blockingPort Blocking Netgear Docsis 3.0 N450 Wi-Fi Data Gateway Port Triggering  To configure port triggeringSelect the Respond to Ping on WAN Port check box  To set up a DMZ hostDMZ Host  To configure LAN IP settings LAN IP SetupClick Delete LAN SwitchReserve an IP Address for Dhcp Use  To reserve an IP address for Dhcp To configure UPnP Configure Universal Plug and Play UPnP To configure the switch ports  To disable a LAN portSet Networking Protocols  To enable NTP To remove a USB device Enable Network Address Translation To disable NAT Remove USB DevicesSee Troubleshoot a TCP/IP Network Using a Ping Utility on TroubleshootingLED Behavior Action Basic FunctionsConnect to the Gateway’s Main Menu Troubleshoot the ISP Connection Troubleshoot a TCP/IP Network Using a Ping UtilityPing Test the LAN Path to Your GatewayNetgear Docsis 3.0 N450 Wi-Fi Data Gateway Supplemental Information Feature Parameter Default Factory Default SettingsComponent Specification Technical SpecificationsNetgear Docsis 3.0 N450 Wi-Fi Data Gateway Regulatory Compliance Information Notification of ComplianceFCC Caution Avertissement