NETGEAR CG3000Dv2 user manual Gateway Rear Panel, Gateway rear panel

Page 8

NETGEAR DOCSIS 3.0 N450 Wi-Fi Data Gateway

Gateway Rear Panel

Ethernet LAN ports

USB port

Reset button

Coaxial cable connector

Power adapter input

Figure 2. Gateway rear panel

The rear panel includes the following connectors, viewed from top to bottom:

Four Gigabit Ethernet LAN ports. To connect local computers, use these ports.

USB port. To connect a USB hard drive, flash drive, or printer, use this port.

Reset. To set the gateway to the original factory settings, press and hold the Reset button for over 7 seconds. See Factory Default Settings on page 54.

Coaxial cable connector. Attach a coaxial cable to the cable service provider’s connection.

Power. Power adapter input.

Connecting to the Internet

8

Image 8
Contents August 2013 East Plumeria Drive San Jose, CA USARevision History Contents Appendix a Supplemental Information Connecting to the Internet Gateway Front Panel DescriptionSecurity, see the Use Push N Connect WPS Wireless Setup on Gateway Rear Panel Gateway rear panelWireless Performance and Gateway Location LabelLog In to Your Gateway  To log in to the gatewayView Basic Settings  To view or configure basic settingsConfiguring Your Wireless Network Set Up Your Wireless Network  To view or configure the wireless settingsNetgear Docsis 3.0 N450 Wi-Fi Data Gateway Use Push N Connect WPS Wireless Setup Netgear Docsis 3.0 N450 Wi-Fi Data Gateway Add a Client Using a PIN  To add a wireless device to your gateway using a PINSet Up Wi-Fi Multimedia  To set up Wi-Fi MultimediaChange the Password  To change the passwordPage Filtering Content View Denial of Service DoS Attack Logs  To receive notification of attacks by emailClick Remove Keyword  To block access to certain domains Limit Internet Site Access To block access to sites containing certain words Allow Unrestricted Access Disable Gateway FeaturesFeature Description  To disable specific web features To disable specific NAT ALG Status features Netgear Docsis 3.0 N450 Wi-Fi Data Gateway Maintaining Your Network Modem field Description View the Gateway Status To view the gateway status View the Connection Status Back Up and Restore Your Settings To view the gateway’s initialization procedure View the Event Log  To back up the settings To restore the backup settings  To run a ping test Run the Diagnostic Utilities To view the event log Click Start Test Traceroute Utility  To run a traceroute testAdvanced Settings Advanced Wireless Settings Description Advanced Wireless Settings To configure advanced wireless settings MAC Filtering  To stop blocking a computer  To remove a computer from the list To delete a device from the IP Filter List  To set up IP filteringIP Filtering Port Forwarding  To configure port blockingPort Blocking Netgear Docsis 3.0 N450 Wi-Fi Data Gateway  To configure port triggering Port TriggeringSelect the Respond to Ping on WAN Port check box  To set up a DMZ hostDMZ Host LAN IP Setup  To configure LAN IP settingsLAN Switch Reserve an IP Address for Dhcp Use To reserve an IP address for Dhcp Click DeleteConfigure Universal Plug and Play UPnP  To configure the switch ports To disable a LAN port  To configure UPnP To enable NTP Set Networking ProtocolsEnable Network Address Translation  To disable NATRemove USB Devices  To remove a USB deviceTroubleshooting See Troubleshoot a TCP/IP Network Using a Ping Utility onLED Behavior Action Basic FunctionsConnect to the Gateway’s Main Menu Troubleshoot a TCP/IP Network Using a Ping Utility Troubleshoot the ISP ConnectionTest the LAN Path to Your Gateway PingNetgear Docsis 3.0 N450 Wi-Fi Data Gateway Supplemental Information Factory Default Settings Feature Parameter DefaultTechnical Specifications Component SpecificationNetgear Docsis 3.0 N450 Wi-Fi Data Gateway Notification of Compliance Regulatory Compliance InformationFCC Caution Avertissement