NETGEAR CG3000Dv2 user manual Notification of Compliance, Regulatory Compliance Information

Page 57

B. Notification of Compliance

B

 

 

 

 

Regulatory Compliance Information

This section includes user requirements for operating this product in accordance with National laws for usage of radio spectrum and operation of radio devices. Failure of the end user to comply with the applicable requirements may result in unlawful operation and adverse action against the end-user by the applicable National regulatory authority.

This product's firmware limits operation to only the channels allowed in a particular Region or Country. Therefore, all options described in this user's guide may not be available in your version of the product.

Europe – EU Declaration of Conformity

Products bearing the marking comply with the following EU directives:

EMC Directive 2004/108/EC

Low Voltage Directive 2006/95/EC

If this product has telecommunications functionality, it also complies with the requirements of the following EU Directive:

R&TTE Directive 1999/5/EC

Compliance with these directives implies conformity to harmonized European standards that are noted in the EU Declaration of Conformity.

For indoor use only. Valid in all EU member states, EFTA states, and Switzerland.

This device may not be used for setting up outdoor radio links in France and in some areas the RF output power may be limited to 10 mW EIRP in the frequency range of 2454 - 2483.5 MHz. For detailed information the end-user should contact the national spectrum authority in France.

FCC Requirements for Operation in the United States

FCC Information to User

This product does not contain any user serviceable components and is to be used with approved antennas only. Any product changes or modifications will invalidate all applicable regulatory certifications and approvals.

FCC Guidelines for Human Exposure

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

FCC Declaration of Conformity

We, NETGEAR, Inc., 350 East Plumeria Drive, San Jose, CA 95134, declare under our sole responsibility that the NETGEAR DOCSIS 3.0 N450 Wi-Fi Data Gateway complies with Part 15 Subpart B of FCC CFR47 Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and

This device must accept any interference received, including interference that may cause undesired operation.

57

Image 57
Contents USA August 2013 East Plumeria Drive San Jose, CARevision History Contents Appendix a Supplemental Information Connecting to the Internet Description Gateway Front PanelSecurity, see the Use Push N Connect WPS Wireless Setup on Gateway rear panel Gateway Rear PanelLabel Wireless Performance and Gateway Location To log in to the gateway Log In to Your Gateway To view or configure basic settings View Basic SettingsConfiguring Your Wireless Network  To view or configure the wireless settings Set Up Your Wireless NetworkNetgear Docsis 3.0 N450 Wi-Fi Data Gateway Use Push N Connect WPS Wireless Setup Netgear Docsis 3.0 N450 Wi-Fi Data Gateway  To add a wireless device to your gateway using a PIN Add a Client Using a PIN To set up Wi-Fi Multimedia Set Up Wi-Fi Multimedia To change the password Change the PasswordPage Filtering Content  To receive notification of attacks by email View Denial of Service DoS Attack LogsLimit Internet Site Access  To block access to sites containing certain wordsClick Remove Keyword  To block access to certain domains Disable Gateway Features Allow Unrestricted Access To disable specific web features  To disable specific NAT ALG Status featuresFeature Description Netgear Docsis 3.0 N450 Wi-Fi Data Gateway Maintaining Your Network View the Gateway Status  To view the gateway statusModem field Description Back Up and Restore Your Settings  To view the gateway’s initialization procedureView the Connection Status  To back up the settings  To restore the backup settingsView the Event Log Run the Diagnostic Utilities  To view the event log To run a ping test Click Start Test  To run a traceroute test Traceroute UtilityAdvanced Settings Advanced Wireless Settings  To configure advanced wireless settingsAdvanced Wireless Settings Description MAC Filtering  To remove a computer from the list  To stop blocking a computer To set up IP filtering IP Filtering To delete a device from the IP Filter List  To configure port blocking Port BlockingPort Forwarding Netgear Docsis 3.0 N450 Wi-Fi Data Gateway Port Triggering  To configure port triggering To set up a DMZ host DMZ HostSelect the Respond to Ping on WAN Port check box  To configure LAN IP settings LAN IP SetupReserve an IP Address for Dhcp Use LAN Switch To reserve an IP address for Dhcp Click Delete To configure the switch ports Configure Universal Plug and Play UPnP To disable a LAN port  To configure UPnPSet Networking Protocols  To enable NTP To disable NAT Enable Network Address TranslationRemove USB Devices  To remove a USB deviceSee Troubleshoot a TCP/IP Network Using a Ping Utility on TroubleshootingBasic Functions Connect to the Gateway’s Main MenuLED Behavior Action Troubleshoot the ISP Connection Troubleshoot a TCP/IP Network Using a Ping UtilityPing Test the LAN Path to Your GatewayNetgear Docsis 3.0 N450 Wi-Fi Data Gateway Supplemental Information Feature Parameter Default Factory Default SettingsComponent Specification Technical SpecificationsNetgear Docsis 3.0 N450 Wi-Fi Data Gateway Regulatory Compliance Information Notification of ComplianceFCC Caution Avertissement