3Com 4210G manual One-port 10 GE XFP Interface Module, Distance

A dual-port 10 GE XFP interface module provides two 10 Gbps XFP optical ports. You can insert an XFP transceiver into the port to connect it to another XFP port through an optical fiber. You can select the following XFP transceivers in Table 1-17 as required.

Table 1-17XFP transceivers supported by 10 GE XFP interface module

	Central			Max
Transceiver		Connector	Fiber	transmission
	wavelength
				distance
			50/125 µm multimode	300 m (984.25 ft.)
			optical fiber
XFP-SX-MM850	850 nm
			62.5/125 µm	33 m (108.27 ft.)
			multimode optical fiber
		LC
XFP-LX-SM1310	1310 nm		9/125 µm single mode	10 km (6.21 mi.)
			optical fiber
XFP-LH40-SM1550-F1	1550 nm		9/125 µm single mode	40 km (24.85 mi.)
			optical fiber

z

z

You are recommended to use XFP transceivers of 3Com on the Switch 4210G.

The types of XFP transceivers may vary over time. Consult 3Com marketing personnel or technical support personnel to obtain the latest information about XFP transceivers.

One-port 10 GE XFP Interface Module

Figure 1-18One-port 10 GE XFP interface module

Figure 1-19Front panel of one-port 10 GE XFP interface module

This module provides one 10 Gbps XFP optical interface. You can select the following XFP transceivers as required. A one-port 10 GE XFP interface module provides one 10 Gbps XFP optical port. You can

1-17