2 Preparing for Installation
Safety Precautions
Before you install or remove any components from the Switch or carry out any maintenance procedures, you must read the 3Com Switch Family Safety and Regulatory Information document enclosed with your switch.
To avoid damage to human body and devices, please read the following safety recommendations carefully before installing the Switch 4210G. The recommendations do not cover every possible hazardous condition.
z
z
z
z
z z
z
Before cleaning the switch, unplug the power plug of the switch first. Do not clean the switch with wet cloth or liquid.
Do not place the switch near water or in a damp environment. Prevent water or moisture from entering the switch chassis.
Do not place the switch on an unstable case or desk. The switch might be damaged severely in case of a fall.
Ensure proper ventilation of the equipment room and keep the ventilation vents of the switch free of obstruction.
Make sure that the operating voltage is the same as the voltage labeled on the switch.
Do not open the chassis while the switch is operating or when electrical hazards are present to avoid electrical shocks.
When replacing interface modules, wear
Installation Site
The Switch 4210G must be used indoors. You can mount your switch in a rack or on a workbench, but make sure:
z
z
z
z
Adequate clearance is reserved at the air inlet/exhaust vents for ventilation. The rack or workbench has a good ventilation system.
The rack is sturdy enough to support the device and its accessories. The rack or workbench is well earthed.
To ensure normal operation and long service life of your switch, install it in an environment that meets the requirements described in the following subsections.