Wacom DTU-710 manual

Page 15

3.

4.

5.

Hold the pen as you normally do, and use the pen tip to click on the cross-hairs in the upper-left corner.

Then click on the cross-hairs that are displayed in the lower-right corner. (For Windows systems, you will need to click APPLY or OK for the changes to take effect.)

Test the alignment and click OK to accept the calibration. Click TRY AGAIN to recalibrate.

Be sure to read the directions in the calibration screen for detailed instructions and additional options. The calibration setting applies to all applications.

Note

If more than one pen display tablet is installed on your system, the control panel will change the settings for the tablet that was last used before opening the control panel.

To calibrate two pen display tablets, ﬁrst touch the pen to tablet #1 and open the control panel without touching the pen to tablet #2. In the control panel, select the correct monitor and calibrate tablet #1. Close the control panel, touch the pen to tablet #2, and again open the control panel without touching the pen to tablet #1. Select the correct monitor and calibrate tablet #2.

15

Image 15

Contents Introduction and Overview Precautions on Use and Handling Page Table of Contents Checking Packed Components Connect DTU-710 to a computer as adisplay Connect DTU-710 to a computerConnect one cable onl y To serial port Windows Tablet Driver InstallationWindows XP Uninstalling The DTU-710Opening the Wacom Tablet Control Panel Customizing The DTU-710 The BasicsCustomizing The Pen Control Panel BasicsSide switch Control Panel DetailsPen Tip Feel & Eraser Feel Modifier Cross-hairs Calibrating the DTU-710Page Front View DTU-710 Component FunctionsStand Stand Adjustment LeverConnector Panel Cover Rear ViewUsing an Alternate Mount or Stand Pen Tip Using the PenSide Switch and Second Side Switch PenRemoving the Side Switch Using a PenTo reinstall the side switch, reverse the above procedure Working with OSD On Screen Display Menu Adjusting the LCD MonitorFactory Presets, Multi-sync, and User Settings Contrast Phase VGA onlyBacklight Vertical Center ResetHorizontal CenterVGA only Menu Position ColorAdjusting Pitch and Phase VGA only Hint Power SavingCleaning Caring for DTU-710Replacing the Pen Tip Troubleshooting Display TroubleshootingGeneral Display Problems VGA Problems TroubleshootingGeneral Problems Pen Tablet TroubleshootingTroubleshooting Windows\System32 folder. Then restart your computer. When Windows-Speciﬁc Problems Macintosh-Speciﬁc Problems General Speciﬁcations SpeciﬁcationsPower Adaptor Obtaining Technical Support Support StaffAsia Trademarks