Wacom DTU-710 manual Precautions on Use and Handling

Page 2

Precautions on Use and Handling

Be sure to follow all instructions, cautions, and warnings found within this manual. Failure to do so could cause the loss of data or damege of your computer. Failure to do so could also void your warranty, in which case Wacom shall have no responsibility for such loss or damage and to repair or replace the product.

WARNING

■Do not use DTU-710 Interactive Pen Display in a facility control system that requires extremely high reliability; it may cause other electronic devices to malfunction, or other devices may cause DTU-710 to malfunction. Where use is prohibited, power off DTU-710 to prevent the possibility of it causing other electronic devices to malfunction. Wacom does not accept any liability for direct or consequential damages. For details, please refer to your Warranty, located at the inside back cover of this manual.

■Only use the AC adaptor that came with DTU-710. If a different type of AC adaptor is used, DTU-710 will not work properly or it may be damaged. Using a different type of AC adaptor also has the potential to result in fire. Use of a different AC adaptor will void your warranty.

■If the LCD screen has been damaged, DO NOT touch any liquid that may be leaking from it; this liquid is an irritant. In case of contact with skin, eyes, or mouth, rinse immediately with running water for at least 15 minutes or more. If contact is made with the eyes or mouth, also consult a physician.

■Prevent your children from swallowing the pen nib or side switch knob.

The pen nib or side switch knob may accidentally be pulled out if children are biting on them.

■ HIGH VOLTAGE. Do not open DTU-710. It has the risk of electric shock.

CAUTION

■When adjusting the tilt angle of DTU-710, be careful to avoid catching your finger in the gap of the movable portion of the stand.

■Be sure to use a grounded power source when applying power to DTU-710.

■Do not lift DTU-710 by the stand; this may damage the stand mechanism. When lifting or moving DTU-710, always do so by grasping the main body casing.

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Introduction and Overview Precautions on Use and Handling Page Table of Contents Checking Packed Components Connect DTU-710 to a computer Connect DTU-710 to a computer as adisplayConnect one cable onl y To serial port Tablet Driver Installation WindowsUninstalling The DTU-710 Windows XPCustomizing The DTU-710 The Basics Opening the Wacom Tablet Control PanelControl Panel Basics Customizing The PenPen Tip Feel & Eraser Feel Side switchControl Panel Details Modifier Calibrating the DTU-710 Cross-hairsPage DTU-710 Component Functions Front ViewRear View Stand Adjustment LeverConnector Panel Cover StandUsing an Alternate Mount or Stand Pen Using the PenSide Switch and Second Side Switch Pen TipUsing a Pen Removing the Side SwitchTo reinstall the side switch, reverse the above procedure Contrast Phase VGA only Adjusting the LCD MonitorFactory Presets, Multi-sync, and User Settings Working with OSD On Screen Display MenuColor Vertical Center ResetHorizontal CenterVGA only Menu Position BacklightAdjusting Pitch and Phase VGA only Power Saving HintReplacing the Pen Tip CleaningCaring for DTU-710 General Display Problems TroubleshootingDisplay Troubleshooting Troubleshooting VGA ProblemsPen Tablet Troubleshooting General ProblemsTroubleshooting Windows\System32 folder. Then restart your computer. When Windows-Specific Problems Macintosh-Specific Problems Specifications General SpecificationsPower Adaptor Asia Obtaining Technical SupportSupport Staff Trademarks
Top Page Image Contents