Wacom manual Caring for DTU-710, Cleaning, Replacing the Pen Tip

Page 26

Caring for DTU-710

Cleaning

To clean the DTU-710 casing, use a soft cloth with mild detergent (such as dish washing liquid) diluted with water. Do not use paint thinner, benzine, alcohol, or other organic solvents to clean DTU-710 casing or pen.

To clean the display screen, use a soft, dry cloth. If necessary, slightly moisten the cloth with water and try again. When cleaning, apply only a light amount of pressure to the display screen and do not make the surface wet. Do not use detergent to clean the display screen; this may damage the coating on the screen. Please note that damage of this kind is not covered by the manufacturer's warranty.

Replacing the Pen Tip

The pen tip will wear with normal use. When the nib gets too short, you can replace it with one of the extra nibs that came with your pen. If the pen tip wears and becomes angular, it may damage the coating on the cover glass of DTU-710 Interactive Pen Display. To avoid this, periodic nib replacement is recommended.

To remove the old nib:

To insert a new nib:

Clasp it with a pair of tweezers or similar instrument and pull the old nib straight out of the pen.

Slide it straight into the barrel of the pen. Firmly push the nib until it stops. The new nib will slide into the correct position.

CAUTION

Prevent your children from swallowing the pen nib or side switch. The pen nib or side switch may accidentally be pulled out if children are biting on them.

26

Image 26
Contents Introduction and Overview Precautions on Use and Handling Page Table of Contents Checking Packed Components Connect DTU-710 to a computer Connect DTU-710 to a computer as adisplayConnect one cable onl y To serial port Tablet Driver Installation WindowsUninstalling The DTU-710 Windows XPCustomizing The DTU-710 The Basics Opening the Wacom Tablet Control PanelControl Panel Basics Customizing The PenPen Tip Feel & Eraser Feel Side switchControl Panel Details Modifier Calibrating the DTU-710 Cross-hairsPage DTU-710 Component Functions Front ViewRear View Stand Adjustment LeverConnector Panel Cover StandUsing an Alternate Mount or Stand Pen Using the PenSide Switch and Second Side Switch Pen TipUsing a Pen Removing the Side SwitchTo reinstall the side switch, reverse the above procedure Contrast Phase VGA only Adjusting the LCD MonitorFactory Presets, Multi-sync, and User Settings Working with OSD On Screen Display Menu Color Vertical Center Reset Horizontal CenterVGA only Menu Position BacklightAdjusting Pitch and Phase VGA only Power Saving HintReplacing the Pen Tip CleaningCaring for DTU-710 General Display Problems TroubleshootingDisplay Troubleshooting Troubleshooting VGA ProblemsPen Tablet Troubleshooting General ProblemsTroubleshooting Windows\System32 folder. Then restart your computer. When Windows-Specific Problems Macintosh-Specific Problems Specifications General SpecificationsPower Adaptor Asia Obtaining Technical SupportSupport Staff Trademarks