Wacom DTU-710 manual

Page 3

CAUTION

Do not put heavy articles on DTU-710; this may damage the display screen or stand.

Do not place heavy article on DTU-710 cabling, repeatedly bend the cables, or apply heavy stress on the cable connectors; this may damage the unit or your cabling.

This product is for use with a VGA or DVI graphics card; using an inappropriate graphics card may damage DTU-710.

Do not connect or disconnect the DVI video cable or power cable while DTU-710 and your computer is turned on; it may damage the LCD display or computer video card.

Do not disassemble DTU-710 or pen. This may cause DTU-710 or pen to malfunction. In this case, Wacom shall have no responsibility to repair or replace the product.

Do not use or store DTU-710 where:

-Temperature changes are severe (e.g., outdoors or inside a vehicle).

-DTU-710 and pen are exposed to direct sunlight or heat from a heating appliance.

-DTU-710 and pen are exposed to water or any other kind of liquid.

-Temperature or humidity exceeds the specifications.

Do not block the ventilation holes in the rear panel; this may overheat and damage DTU-710.

Do not use DTU-710 in a dusty environment; It may damage the unit.

Do not scratch the cover glass of DTU-710. Avoid placing sharp objects on the glass surface.

Do not use detergent to clean the cover glass of DTU-710; this may alter the surface friction and deteriorate the handwriting feel.

3

Image 3
Contents Introduction and Overview Precautions on Use and Handling Page Table of Contents Checking Packed Components Connect DTU-710 to a computer as adisplay Connect DTU-710 to a computerConnect one cable onl y To serial port Windows Tablet Driver InstallationWindows XP Uninstalling The DTU-710Opening the Wacom Tablet Control Panel Customizing The DTU-710 The BasicsCustomizing The Pen Control Panel BasicsSide switch Control Panel DetailsPen Tip Feel & Eraser Feel Modifier Cross-hairs Calibrating the DTU-710Page Front View DTU-710 Component FunctionsStand Stand Adjustment LeverConnector Panel Cover Rear ViewUsing an Alternate Mount or Stand Pen Tip Using the PenSide Switch and Second Side Switch PenRemoving the Side Switch Using a PenTo reinstall the side switch, reverse the above procedure Working with OSD On Screen Display Menu Adjusting the LCD MonitorFactory Presets, Multi-sync, and User Settings Contrast Phase VGA onlyBacklight Vertical Center ResetHorizontal CenterVGA only Menu Position ColorAdjusting Pitch and Phase VGA only Hint Power SavingCleaning Caring for DTU-710Replacing the Pen Tip Troubleshooting Display TroubleshootingGeneral Display Problems VGA Problems TroubleshootingGeneral Problems Pen Tablet TroubleshootingTroubleshooting Windows\System32 folder. Then restart your computer. When Windows-Specific Problems Macintosh-Specific Problems General Specifications SpecificationsPower Adaptor Obtaining Technical Support Support StaffAsia Trademarks