Menu Commands Parameter Messages
In serial mode, most menu commands when scanned will provide a confirmation message to the host along with the ACK. This feature can be enabled or disabled.
BA
BB
Enable Parameter Messages *
Disable Parameter Messages
External Trigger Operation
External trigger operation enables an external device to control scan- ning. External trigger is controlled by applying an external trigger signal to the CTS input (with external triggering enabled). When active, this signal causes scanning to begin just as if the scanner’s trig- ger were depressed. Scanning continue until a label is decoded or the external trigger signal is deactivated.
In the event of a decode, the trigger signal must be deactivated for a minimum of 50 milliseconds before another scan can be attempted (“tying” the trigger signal active does not cause continuous scanning and decoding).
When EXTERNAL TRIGGER(+) is scanned, scanning begins when a high level input is applied to the CTS input. Conversely, when EXTERNAL
HA
Disable External Trigger#*@
HE
External Trigger(+)
20 | User’s / Programming Guide |