Datalogic Scanning DS1100 SH2347 Connecting the Power Supply, Connecting a Magnetic Stripe Reader

Connecting the Power Supply

If supplied, plug the connector from the external power supply into the receptacle located on the housing connector. Then plug the power supply into a power source.

Connecting a Magnetic Stripe Reader

If a detached Magnetic Stripe Reader (MSR) is to be used, plug the connector into the MSR receptacle located on the housing connector.

Terminal Power-Up Sequence

Turn on the power to the terminal to which the PSC scanner is con- nected. The unit will issue a series of beeps which are intentional and indicate that the terminal/keyboard power-on reset routines have been completed.

Programming for Terminal Type

If this is a first-time installation, it is NECESSARY to pro-

gram the PSC scanner for use with the connected termi-

nal.

NOTE

Proceed as follows:

1.Using the Keyboard Wedge Parameters menu given in the Keyboard Wedge Parameters Section scan:

WEDGE MODE ENABLE (CE)

This sets the PSC scanner into a Keyboard Wedge interface mode.

2.Select the terminal type by next scanning the appropriate symbol for your terminal.

Scanning Reset to Default (ZA) will cause the PSC scan-

ner to revert to Keyboard Wedge mode with a PC-AT termi-

nal type.

NOTE

06656 3