Barco E-2320 C (SE) system manual Detailed installation, To perform a quick installation

Installing your Barco display controller

To perform a quick installation

CAUTION – Wear a grounded, protective ESD strap when handling or during installation of the display controller. Electrostatic charges can damage the display controller.

1.If you are not going to use your old graphics card, uninstall the drivers and software for it if you have not already done so.

Note: If you are using a motherboard containing an on-board graphics solution and do not intend to use it as part of a multiple-display setup, disable it either in the computer’s System Set-up utility (BIOS) or the Windows device manager.

2.Shut down and disconnect your computer system.

3.If necessary, remove any previously installed graphics card.

4.Install the display controller(s) for your BARCO Display System.

5.Reassemble and connect your computer system.

6.Install the drivers, QAWeb software and documentation for your BARCO NIO Display System by following the instructions in the section “Installing drivers and software” on page 49 of this manual.

Detailed installation

The following instructions will take you step by step through the installation of the display controller(s) for your BARCO Display System.

CAUTION – Wear a grounded, protective ESD strap when handling or during installation of the display controller. Electrostatic charges can damage the display controller.

1.If you are not going to use your old graphics card, uninstall the drivers and software for it if you have not already done so.

2.Turn off the computer, display(s), and other peripheral devices.

34