Barco E-2320 C (SE) system manual Automated display configuration

Installing drivers and software

7.When the Setup complete message appears, select Reboot System Now and click Finish.

8.After the system reboots, Windows may display either the

Digital Signature Not Found message or The software you are installing for this hardware has not passed Windows logo testing to verify its compatibility with Windows XP message. If it does click Yes or Continue to complete the driver and software installation.

Automated display configuration

Once the drivers, software and documentation have been installed and your system has been rebooted, the Barco Monitor Plug and Play Software should automatically detect your Barco displays and attach them to the desktop with the correct resolution.

Reinstalling drivers

You can install new drivers or reinstall existing drivers at any time by using the Barco Set-up wizard on your BARCO NIO Display System Installation CD-ROM, see Installing the BARCO MXRT drivers and software, on page 49 of this manual.

Uninstalling the drivers and software

To uninstall the Barco drivers, software or documentation for your E- 2320 C Systems, please use the Windows Add/Remove Programs utility. This can be found in the Windows Control Panel.

Note: When uninstalling the Barco MXRT drivers, the devices must be uninstalled in pairs. When the dialog box shown in figure 19 appears select all of the devices listed.

52